CFR Part 1120

CFR Part 1120
in effect

16 C.F.R. § 1120.1 Authority.

Under the authority of section 15(j) of the Consumer Product Safety Act (CPSA), the Commission determines that consumer products or classes of consumer products listed in § 1120.3 of this part have characteristics whose existence or absence present a substantial product hazard under section 15(a)(2) of the CPSA. The Commission has determined that the listed products have characteristics that are readily observable and have been addressed by a voluntary standard, that the voluntary standard has been effective, and that there is substantial compliance with the voluntary standard. The listed products are subject to the reporting requirements of section 15(b) of the CPSA and to the recall provisions of section 15(c) and (d) of the CPSA, and shall be refused entry into the United States under section 17(a)(4) of the CPSA.

16 C.F.R. § 1120.2 Definitions.

The definitions in section 3 of the Consumer Product Safety Act (15 U.S.C. 2052) apply to this part 1120. (a) Substantial product hazard means a product defect which (because of the pattern of defect, the number of defective products distributed in commerce, the severity of the risk, or otherwise) creates a substantial risk of injury to the public. (b) Hand-supported hair dryer means an electrical appliance, intended to be held with one hand during use, which creates a flow of air over or through a self-contained heating element for the purpose of drying hair. (c) Drawstring means a non-retractable cord, ribbon, or tape of any material to pull together parts of upper outerwear to provide for closure. (d) Seasonal and decorative lighting product means portable, plug-connected, temporary-use lighting products and accessories that have a nominal 120 volt input voltage rating. Lighting products within the scope of the rule are factory-assembled with push-in, midget- or miniature-screw base lampholders connected in series or with candelabra- or intermediate-screw base lampholders connected in parallel, directly across the 120 volt input. Such lighting products include lighted decorative outfits, such as stars, wreathes, candles without shades, light sculptures, blow-molded (plastic) figures, and animated figures. Lighting products outside the scope of the rule include: Battery-operated products; solar-powered products; products that operate from a transformer or low-voltage power supply; flexible lighting products incorporating non-replaceable series and series/parallel connected lamps enclosed within a flexible polymeric tube or extrusion; and portable electric lamps that are used to illuminate seasonal decorations. (e) Extension cord (also known as a cord set) means a length of factory-assembled flexible cord with an attachment plug or current tap as a line fitting and with a cord connector as a load fitting. Extension cords are used for extending a branch circuit supply of an electrical outlet to the power-supply cord of a portable appliance, in accordance with the National Electrical Code.® For purposes of this rule, the term applies to extension cords that are equipped with National Electrical Manufacturer Association (“NEMA”) 1-15, 5-15 and 5-20 fittings, and that are intended for indoor use only, or for both indoor and outdoor use. The term “extension cord” does not include detachable power supply cords, appliance cords, power strips and taps, and adaptor cords supplied with outdoor tools and yard equipment. (f) Stock window covering (also known as a stock blind, shade, or shading) has the same meaning as defined in section 3, definition 5.02, of ANSI/WCMA A100.1—2018 (incorporated by reference; see § 1120.4), as a window covering that is completely or substantially fabricated prior to being distributed in commerce and is a specific stock-keeping unit (SKU). Even when the seller, manufacturer, or distributor modifies a pre-assembled product by adjusting to size, attaching the top rail or bottom rail, or tying cords to secure the bottom rail, the product is still considered stock. Online sales of the product or the size of the order such as multi-family housing do not make the product a non-stock product. These examples are provided in ANSI/WCMA A100.1—2018 (incorporated by reference; see § 1120.4) to clarify that as long as the product is “substantially fabricated” prior to distribution in commerce, subsequent changes to the product do not change its categorization. (g) Custom window covering (also known as a custom blind, shade, or shading) has the same meaning as defined in section 3, definition 5.01, of ANSI/WCMA A100.1—2018 (incorporated by reference; see § 1120.4), as a window covering that does not meet the definition of a stock window covering.

16 C.F.R. § 1120.3 Products deemed to be substantial product hazards.

The following products or class of products shall be deemed to be substantial product hazards under section 15(a)(2) of the CPSA: (a) Hand-supported hair dryers that do not provide integral immersion protection in compliance with the requirements of section 5 of UL 859, or section 6 of UL 1727 (incorporated by reference, see § 1120.4). (b)(1) Children's upper outerwear in sizes 2T to 16 or the equivalent, and having one or more drawstrings, that is subject to, but not in conformance with, the requirements of ASTM F 1816-97 (incorporated by reference, see § 1120.4). (2) At its option, the Commission may use one or more of the following methods to determine what sizes of children's upper outerwear are equivalent to sizes 2T to 16: (i) Garments in girls' size Large (L) and boys' size Large (L) are equivalent to girls' or boys' size 12, respectively. Garments in girls' and boys' sizes smaller than Large (L), including Extra-Small (XS), Small (S), and Medium (M), are equivalent to sizes smaller than size 12. The fact that an item of children's upper outerwear with a hood and neck drawstring is labeled as being larger than a size Large (L) does not necessarily mean that the item is not equivalent to a size in the range of 2T to 12. (ii) Garments in girls' size Extra-Large (XL) and boys' size Extra-Large (XL) are equivalent to size 16. The fact that an item of children's upper outerwear with a waist or bottom drawstring is labeled as being larger than size Extra-Large (XL) does not necessarily mean that the item is not equivalent to a size in the range of 2T to 16. (iii) In cases where garment labels give a range of sizes, if the range includes any size that is subject to a requirement in ASTM F 1816-97, the garment will be considered subject, even if other sizes in the stated range, taken alone, would not be subject to the requirement. For example, a coat sized 12 through 14 remains subject to the prohibition of hood and neck area drawstrings, even though this requirement of ASTM F 1816-97 only applies to garments up to size 12. A coat size 13 through 15 would not be considered within the scope of ASTM F 1816-97's prohibition of neck and hood drawstrings, but would be subject to the requirements for waist or bottom drawstrings. (iv) To fall within the scope of paragraphs (b)(2)(i) through (2)(iii) of this section, a garment need not state anywhere on it, or on its tags, labels, package, or any other materials accompanying it, the term “girls,” the term “boys,” or whether the garment is designed or intended for girls or boys. (v) The Commission may use any other evidence that would tend to show that an item of children's upper outerwear is a size that is equivalent to sizes 2T to 16. (c) Seasonal and decorative lighting products that lack one or more of the following characteristics in conformance with requirements in sections 6, 7, 15, 71, 79, and SB15 of UL 588 (incorporated by reference, see § 1120.4): (1) Minimum wire size requirements in section 6 of UL 588; (2) Sufficient strain relief requirements in sections 15, 71, 79, and SB15 of UL 588; or (3) Overcurrent protection requirements in section 7 of UL 588. (d) Extension cords that lack one or more of the following specified characteristics in conformance with requirements in sections 2, 9, 16, 19, 20, 21, 26, 30, 31, 32, 84, and 105 of UL 817 (incorporated by reference, see § 1120.4): (1) Minimum wire size requirement in sections 2, 20, 21, and 30 of UL 817; (2) Sufficient strain relief requirement in sections 20, 30, and 84 of UL 817; (3) Proper polarization requirement in sections 9, 19, 20, 30, 31, and 32 of UL 817; (4) Proper continuity requirement in sections 16, 20, 30, and 105 of UL 817; (5) Outlet cover requirement (for indoor 2-wire parallel extension cords with polarized parallel-blade and -slot fittings) in sections 20 and 26 of UL 817; or (6) Jacketed cord requirement (for outdoor use extension cords) in section 30 of UL 817. (e) Stock window coverings that fail to comply with one or more of the following requirements of ANSI/WCMA A100.1—2018 (incorporated by reference; see § 1120.4): (1) Operating cord requirements in section 4.3.1: section 4.3.1.1 (cordless operating system), 4.3.1.2 (short static or access cord), or 4.3.1.3 (inaccessible operating cord); (2) Inner cord requirements in sections 4.5, 6.3, 6.7, and Appendices C and D; and (3) On-product manufacturer label requirement in section 5.3. (f) Custom window coverings that fail to comply with one or more of the following requirements of ANSI/WCMA A100.1—2018 (incorporated by reference; see § 1120.4): (1) Inner cord requirements in sections 4.5, 6.3, 6.7, and Appendices C and D; and (2) On-product manufacturer label in section 5.3.

16 C.F.R. § 1120.4 Standards incorporated by reference.

(a) The standards required in this part are incorporated by reference (“IBR”) into this section with the approval of the Director of the Federal Register under 5 U.S.C. 552(a) and 1 CFR part 51. You may inspect all approved material at the Office of the Secretary, U.S. Consumer Product Safety Commission, Room 820, 4330 East West Highway, Bethesda, MD 20814, telephone 301-504-7923, or at the National Archives and Records Administration (“NARA”). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html. (b) ASTM International, 100 Barr Harbor Drive, P.O. Box C700, West Conshohocken, PA 19428-2959 USA, telephone: 610-832-9585; http://www2.astm.org/. (1) ASTM F 1816-97, Standard Safety Specification for Drawstrings on Children's Upper Outerwear, approved June 10, 1997, published August 1998 (“ASTM F 1816-97”), IBR approved for § 1120.3(b). (2) [Reserved] (c) Underwriters Laboratories, Inc (“UL”), 333 Pfingsten Road, Northbrook, IL 60062 or through UL's Web site: www.UL.com. (1) UL 588, Standard for Safety for Seasonal and Holiday Decorative Products, 18th Edition, approved August 21, 2000 (“UL 588”), IBR approved for § 1120.3(c). (2) UL 859, Standard for Safety for Household Electric Personal Grooming Appliances, 10th Edition, approved August 30, 2002, and revised through June 3, 2010 (“UL 859”), IBR approved for § 1120.3(a). (3) UL 1727, Standard for Safety for Commercial Electric Personal Grooming Appliances, 4th Edition, approved March 25, 1999, and revised through June 25, 2010 (“UL 1727”), IBR approved for § 1120.3(a). (4) UL 817, Standard for Cord Sets and Power-Supply Cords, 11th Edition, dated March 16, 2001, as revised through February 3, 2014 (“UL 817”), IBR approved for § 1120.3(d). (d) Window Covering Manufacturers Association, Inc., 355 Lexington Avenue, New York, New York 10017. Telephone: 212.297.2122. http://wcmanet.com. (1) ANSI/WCMA A100.1—2018. American National Standard For Safety Of Corded Window Covering Products, approved January 8, 2018. IBR approved for §§ 1120.2 and 1120.3. (2) [Reserved]

Starting a business? Corpus forms LLCs in all 50 states and DC.