Sacramento City Code tit. 17, div. II, ch. 17.228, art. III — Antennas and Telecommunications Facilities | Sacramento City Code (current through Supplement No. 4, July 2026, and Ord. 2026-0022) — Sacramento

Sacramento City Code § 17.228.300 Antenna mounted on existing building or structure.

17.228.300 Antenna mounted on existing building or structure. A. Antenna mounted on existing building or structure-General. Except as provided in section 17.808.160 and subsections B, C, and D of this section, and except for an antenna subject to sections 17.228.310 or 17.228.320, an antenna mounted on an existing building or structure, together with related equipment, is subject to director-level site plan and design review and shall conform to the following development standards: 1. The antenna, and its related equipment, shall not project above the roof parapet or penthouse roof line of the building, or the highest point of the structure to which the antenna is attached, by more than 12 feet. 2. The antenna, and its related equipment, shall not extend out more than six feet from the face of the building or surface of the structure to which is it attached. 3. The antenna panels and all brackets and cables shall be painted to match the building or structure at the point of attachment. 4. The equipment cabinet, if any, is located in one of the following locations: a. On the roof of, or within, the building or structure on which the antenna is mounted; b. Within any building located on the same parcel as the building or structure on which the antenna is mounted; or c. On the ground and outside of any required setback or vehicle maneuvering area on the same parcel as the building or structure on which the antenna is mounted. 5. An equipment cabinet located on a building roof shall conform to the requirements for roof-mounted mechanical equipment in chapter 17.600. B. Antenna mounted on an existing building or structure-Single-unit and duplex dwellings. An antenna shall not be mounted on the exterior of a single-unit or duplex dwelling. C. Antenna mounted on an existing building or structure-Antenna not visible from adjacent streets or public areas. An antenna mounted on an existing building or structure, together with related equipment, that is not visible from adjacent streets or public areas, is subject to staff-level site plan and design review. D. Antenna mounted on an existing building or structure-Panel antenna. 1. Site plan and design review. a. General. Except as provided in subsection b, a panel antenna mounted on an existing building or structure, together with related equipment, is subject to staff-level site plan and design review. b. Historic resources. A panel antenna mounted on a landmark or on an existing building or structure in a historic district, together with related equipment, is permitted subject to director-level site plan and design review. 2. Development standards. A panel antenna mounted on an existing building or structure, together with related equipment, shall conform with the following development standards: a. The antenna, and its related equipment, shall not project above the roof parapet or penthouse roof line of the building, or the highest point of the structure to which the antenna is attached. b. The antenna, and its related equipment, shall not extend out more than 18 inches from the face of the building or surface of the structure to which is it attached. c. The antenna panels and all brackets and cables shall be painted to match the building or structure at the point of attachment. d. The equipment cabinet, if any, shall be located in one of the following locations: i. On the roof of, or within, the building or structure on which the antenna is mounted; ii. Within any building located on the same parcel as the building or structure on which the antenna is mounted; or iii. On the ground and outside of any required setback or vehicle maneuvering area on the same parcel as the building or structure on which the antenna is mounted. e. An equipment cabinet located on a building roof shall conform to the requirements for roof-mounted mechanical equipment in chapter 17.600. (Ord. 2025-0007 § 23; Ord. 2019-006 § 6; Ord. 2013-0020 § 1; Ord. 2013-0007 § 1)

Sacramento City Code § 17.228.310 Panel antenna and satellite dish located on active high voltage electrical transmission towers.

17.228.310 Panel antenna and satellite dish located on active high voltage electrical transmission towers. A panel antenna, or a satellite dish not exceeding 26 inches in diameter, mounted on an active high voltage electrical transmission tower is permitted subject to staff-level site plan and design review, and shall conform to the following development standards: A. The panel antenna or dish shall not exceed the height of the tower by more than 12 feet. B. The panel antenna or dish and all brackets and cables shall be painted to match the structure at the point of attachment. C. The equipment cabinet, if any, is located in one of the following locations: 1. At the base of the tower on which the antenna is mounted; 2. Within any building located on the same parcel as the tower on which the antenna is mounted; or 3. On the ground and outside of any required setback or vehicle maneuvering area on the same parcel as the tower on which the antenna is mounted. (Ord. 2025-0007 § 24; Ord. 2013-0020 § 1; Ord. 2013-0007 § 1)

Sacramento City Code § 17.228.320 Telecommunications tower.

17.228.320 Telecommunications tower. A. Telecommunications tower on residentially zoned lots. A telecommunication tower is prohibited on a residentially zoned lot unless either of the following applies: 1. The residentially zoned lot is developed and used for nonresidential purposes; or 2. The residentially zoned lot is owned by a governmental entity. B. New telecommunications towers. 1. Conditional use permit required. A new telecommunications tower requires approval of either a commission-level or director-level conditional use permit, as follows: a. Director-level-Replacement monopole. A director-level site plan and design review is required for a new monopole that replaces an existing monopole, does not exceed the height of the existing pole or the maximum height limit in the zone where it is located, and is located in the same or proximate location as the monopole being replaced. b. Commission-level. A commission-level conditional use permit is required for a new telecommunications tower that is not subject to director-level review. 2. Site plan and design review. A new telecommunications tower is subject to site plan and design review approval at the same level as the conditional use permit. C. Existing telecommunications towers-Modification. A modification to an existing telecommunications tower is subject to site plan and design review. D. Development standards. 1. The equipment cabinet, if any, shall be located in one of the following locations: a. At the base of the tower on which the antenna is mounted; b. Within any building located on the same parcel as the tower on which the antenna is mounted; or c. On the ground and outside of any required setback and vehicle maneuvering area on the same parcel as the tower on which the antenna is mounted. (Ord. 2025-0007 § 25; Ord. 2013-0020 § 1; Ord. 2013-0007 § 1)