Baseline monitoring reports.
Riverside Municipal Code § 14.12.447
in effect14.12.447 - Baseline monitoring reports.
Reporting requirements for industrial users upon effective date of categorical pretreatment standard baseline report. Within 180 days after the effective date of a categorical Pretreatment Standard, or 180 days after the final administrative decision made upon a category determination submission under Federal Code 40 CFR 403.6(a)(4), whichever is later, existing Industrial Users subject to such categorical Pretreatment Standards and currently discharging to or scheduled to discharge to a POTW shall be required to submit to the Control Authority a report which contains the information as described below. At least 90 days prior to commencement of discharge, New Sources, and sources that become Industrial Users subsequent to the promulgation of an applicable categorical Standard, shall be required to submit to the City of Riverside a report which contains the information required. New sources shall also be required to include in this report information on the method of pretreatment the source intends to use to meet applicable pretreatment standards. New Sources shall give estimates of the information as requested:
1. Identifying information. The user shall submit the name and address of the facility including the name of the operator and owners;
2. Permits. The user shall submit a list of any environmental control permits held by or for the facility;
3. Description of operations. The user shall submit a brief description of the nature, average rate of production, and standard industrial classification of the operation(s) carried out by such industrial user. This description should include a schematic process diagram which indicates points of discharge to the POTW from the regulated processes.
4. Flow measurement. The user shall submit information showing the measured average daily and maximum daily flow, in gallons per day, to the POTW from each of the following:
(i) Regulated process streams; and
(ii) Other streams as necessary to allow use of the combined wastestream formula of 40 CFR 403.6(e).
The City of Riverside may allow for verifiable estimates of these flows where considerations are justified by cost or feasibility.
5. Measurement of pollutants.
(i) The user shall identify the pretreatment standards applicable to each regulated process;
(ii) In addition, the user shall submit the results of sampling and analysis identifying the nature and concentration (or mass, where required by the City of Riverside) of regulated pollutants in the discharge from each regulated process. Both daily maximum and average concentration (or mass, where required) shall be reported. The sample shall be representative of daily operations. In cases where the standard requires compliance with a best management practice or pollution prevention alternative, the user shall submit documentation as required by the City of Riverside or the applicable standards to determine compliance with the standard;
(iii) For sampling required in support of baseline monitoring and 90-day compliance reports required, a minimum of four grab samples must be used for pH, cyanide, total phenols, oil and grease, sulfide and volatile organic compounds for facilities for which historical sampling data do not exist; for facilities for which historical sampling data are available, the Director may authorize a lower minimum. For the reports required under (40 CFR 403.12(e) and 403.12(h)), the industrial user is required to collect the number of grab samples necessary to assess and assure compliance with applicable pretreatment standards and requirements.
(iv) Samples should be taken immediately downstream from pretreatment facilities if such exist or immediately downstream from the regulated process if no pretreatment exists. If other wastewaters are mixed with the regulated wastewater prior to pretreatment the user shall measure the flows and concentrations necessary to allow use of the combined wastestream formula in order to evaluate compliance with the applicable pretreatment standards. Where an alternate concentration or mass limit has been calculated, this adjusted limit along with supporting data shall be submitted to the City of Riverside;
(v) Sampling and analysis shall be performed in accordance with the techniques prescribed in 40 CFR part 136 and amendments thereto. Where 40 CFR part 136 does not contain sampling or analytical techniques for the pollutant in question, or where the Director determines that the part 136 sampling and analytical techniques are inappropriate for the pollutant in question, sampling and analysis shall be performed by using validated analytical methods or any other applicable sampling and analytical procedures, including procedures suggested by the POTW or other parties, and approved by the Director;
(vi) The City may allow the submission of a baseline report which utilizes only historical data so long as the data provides information sufficient to determine the need for industrial pretreatment measures;
(vii) The baseline report shall indicate the time, date and place, of sampling, and methods of analysis, and shall certify that such sampling and analysis is representative of normal work cycles and expected pollutant discharges to the POTW;
6. Certification. A statement, reviewed by an authorized representative of the industrial user and certified to by a qualified professional, indicating whether pretreatment standards are being met on a consistent basis, and, if not, whether additional operation and maintenance (O and M) and/or additional pretreatment is required for the industrial user to meet the pretreatment standards and requirements; and
7. Compliance schedule. If additional pretreatment and/or O and M will be required to meet the pretreatment standards; the shortest schedule by which the industrial user will provide such additional pretreatment and/or O and M. The completion date in this schedule shall not be later than the compliance date established for the applicable pretreatment standard.
(i) Where the industrial user's categorical pretreatment standard has been modified by a removal allowance, the combined wastestream formula, and/or a fundamentally different factors variance at the time the user submits the report required, the information required shall pertain to the modified limits.
(ii) If the categorical pretreatment standard is modified by a removal allowance the combined wastestream formula, and/or a fundamentally different factors variance after the user submits the report required, any necessary amendments to the information requested shall be submitted by the user to the Control Authority within 60 days after the modified limit is approved.
(Ord. 7551 §40, 2021; Ord. 7459 §32, 2019; Ord. 7362 §6, 2017)
Source: City of Riverside, California, Municipal Code and City Charter (Municode Library, library.municode.com)URL: https://library.municode.com/ca/riverside/codes/code_of_ordinances?nodeId=PTIICOOR_TIT14PUUT_CH14.12DIWAINPUSEPOINSTDRSY_DIVIIIINWA_14.12.447BAMOREFetched: 11/1/2026
