Sec. 15-4108. - STREET DESIGN.
Streets shall be designed and constructed consistent with the City's Standard Drawings and Specifications and Public Works Director approval and as provided below.
A. Street Orientation. Streets shall be planned in a primarily east-west orientation in order to best implement Section 15-4113, Energy Conservation, and the Map Act (Section 66473).
B. Local Streets. Local streets shall have minimum right-of-way and roadway widths in accordance with the local street details and development density criteria of the Standard Drawings and Specifications.
C. Connector Streets. Connector Streets shall incorporate coordinated street trees spaced to provide continuous shade for pedestrians. Connector Streets shall be designed with non-contiguous sidewalks to allow the street trees to be planted in a landscape strip between the curb and sidewalk. The planting area shall be a minimum of four feet in width.
D. Major Streets.
1. Major streets shall be as shown on the circulation element of the General Plan, any operative plan or any Official Plan Line, the select system of streets, or as shown on any precise or other plan of streets adopted by the Council or by other legally constituted bodies of city, county or state.
2. All Major Streets shall be designed as Complete Streets. Complete Streets are those that provide for all users of a corridor, including pedestrians, bicyclists, transit riders, people with disabilities, senior citizens, motorists, freight providers, emergency responders, and adjacent land users. Complete Streets support all modes of transportation safely and independently in current and future conditions.
E. Frontage Roads. Existing frontage roads in adjacent subdivisions shall be continued into the proposed subdivision in the same manner as related to width and design. Pedestrian sidewalks and bike paths are required with frontage roads.
F. Private Streets. Private streets are prohibited except where approved as part of a Planned Unit Development or otherwise approved by the City Council. All widths and alignments of private streets shall be as shown on any precise or other plan of streets adopted by the Council and shall conform to the private street details and development criteria of the Standard Drawings and Standard Specifications. Private streets that serve multi-unit dwellings shall comply with Section 15-4105, Lot Access.
G. Street Intersections.
1. All streets shall intersect each other at angles as near to right angles as is practicable.
2. All local street intersections and all intersections with Major Streets shall have minimum curb radii as established in the Standard Drawings, except that at the intersections with State highways, the standards of the California Department of Transportation shall apply.
H. Curves.
1. Unless the curve radius has been established on an adopted map, a curve radius shall be required as determined by the Public Works Director where a street deflects more than five degrees from a straight line.
2. On all streets having reverse curves, a tangent of at least 100 feet between reverse curves shall be required. Subject to the approval of the Public Works Director, these requirements may be varied for local streets or when topography requires other treatment of streets to secure the best overall design.
I. Alleys.
1. Where alleys are planned, required, or proposed, an alley with a minimum width of 20 feet shall be installed, and the alley shall be designed to conform to Public Works Standards.
2. Where two alleys intersect or where an alley deflects with an interior angle of less than 135 degrees, corner cut-offs of 15 feet measured from the point of any interior angle shall be required.
J. Traffic Calming. Traffic calming street design or devices such as bulb-outs, chokers, center islands / raised medians, traffic circles, textured pavement, and painted intersections, shall be included, if required by an operative plan, or when determined to be necessary by the City Engineer, to ensure safe conditions for all users.
K. Cul-de-Sacs and Dead-End Streets.
1. The combined length of all cul-de-sacs and other dead-end streets in any subdivision shall not exceed 35 percent of the combined total length of all local residential streets within the subdivision. Cul-de-sacs that are connected by a trail shall be exempt from this calculation. Additional exceptions may be made at the discretion of the Review Authority if any of the following circumstances apply:
a. The average block length of all blocks in the proposed subdivision is 400 feet or less;
b. The applicant can demonstrate, to the satisfaction of the City Engineer, that the subdivision design will result in a rate of Vehicle Miles Travelled which is equal to or less than a subdivision which follows the cul-de-sac limit in item K-1 above;
c. The site is 6 acres or less in gross area;
d. The site is surrounded by developed properties which lack stubs to connect to; or
e. The site is blocked by canals and expressways.
2. Cul-de-sacs and dead-end streets may not exceed 600 feet unless there are unforeseen issues or topographical challenges or other opportunities to promote pedestrian connectivity such as access to another street or trail.
3. All cul-de-sacs and dead-end streets shall have a turnaround per Public Works Standards.
4. A cul-de-sacs and or dead end street may be approved as a temporary facility, without a turnaround, provided the street is designed to provide access to adjoining land that is not yet subdivided or developed. A temporary turnaround or access may be required.
5. Cul-de-sacs and dead-end streets shall provide pedestrian and bike connections to neighboring streets, trails, commercial centers, etc.
L. Street Names. Refer to Article 62, Street Names & Addressing.
M. Sidewalks.
1. All public streets shall have sidewalks constructed to City standards on at least one side of the street if there is connectivity to one of the following:
a. An adjacent street with a sidewalk;
b. An adjacent trail; or
c. An adjacent alley.
2. Streets with a sidewalk on only one side shall have two 15-gallon street trees in the front of the lot on both sides of the street.
3. Streets that do not provide any of the connections set forth in Subsection 1.a—c above shall have sidewalks constructed to City standards on both sides of the street.
4. Private streets are exempt from this section.
N. Street Trees.
1. Street tree species shall be selected from the Fresno Street Tree Palette.
2. Street trees shall be planted per applicable Public Works standards.
3. Street trees shall be located within a landscaped park strip of no less than four feet in width between the curb and sidewalk.
4. Trees within the front yard of adjacent parcels may be counted toward the satisfaction of this requirement at the discretion of the Review Authority, in which case the landscape strip between the curb and sidewalk will not be required and the spacing shall be one tree per lot.
O. Street Lighting.
1. Installation Required. The subdivider shall cause the installation of street lighting on all streets within the subdivision and on all streets adjacent to the subdivision unless existing lighting conforms to City standards.
2. Specifications. The type, location, and mounting heights of the luminaries shall be determined by the Public Works Director based upon the Standard Specifications and sound engineering practices consistent with the City policy for street lighting.
(Added Ord. 2015-39, § 1, eff. 1-9-16; Am. Ord. 2018-66, §§ 67—69, eff. 1-18-19; Am. Ord. 2025-024, § 74, eff. 7-27-25).