§ 25-116 — Discharge of certain wastes restricted
Code of Ordinances, City of Meridian, Mississippi (Supp. No. 55: codified through Ordinance No. 4604, enacted October 21, 2025) · Meridian Code of Ordinances § 25-116
Corpus is an independent public-information project, not the official City of Meridian website. Stable reference: corpuslaw.us/code/201dd9cf-5a26-44d8-9f83-53b22432e0db
Sec. 25-116. - Discharge of certain wastes restricted.
No person shall discharge or cause to be discharged the following described substances, materials, waters, or wastes if it appears likely in the opinion of the city engineer that such wastes can harm either the wastewater collection and transmission system, wastewater treatment plant, or equipment, have an adverse effect on the receiving stream, or can otherwise endanger life, limb, public property, or constitute a nuisance. In forming his opinion as to the acceptability of these wastes, the city engineer will give consideration to such factors as the quantities of subject wastes in relation to flows and velocities in the sewers, materials of construction of the sewers, nature of the sewage treatment process, capacity of the wastewater treatment plant, degree of treatability of wastes in the wastewater treatment plant, and other pertinent factors. The substances prohibited are: (1) Any substance which will cause the wastewater treatment plant to violate its national pollution discharge elimination system and/or state disposal system permit or the receiving water quality standards. (2) Any substance which may cause the wastewater treatment plant effluent or any other product of the treatment facility such as residues, sludges, or scums, to be unsuitable for reclamation and reuse or to interfere with the reclamation process. In no case, shall a substance discharged to the wastewater treatment plant cause the plant to be in noncompliance with sludge use or disposal criteria, guidelines or regulations developed under Section 405 of the Clean Water Act, as amended, 33 U.S.C. 1251, et seq.; any criteria, guidelines, or regulations affecting sludge use or disposal developed pursuant to the Solid Waste Disposal Act, the Clean Air Act, the Toxic Substances Control Act, or state criteria applicable to the sludge management method being used. (3) Any wastewater having a temperature which will inhibit biological activity in the sewage works resulting in interference, but in no case wastewater with a temperature at the introduction into the wastewater collection and transmission system or wastewater treatment plant which exceeds forty (40) degrees Celsius (one hundred four (104) degrees Fahrenheit). (4) Any water or waste containing fats, wax, grease, or oils, whether emulsified or not, in excess of 100 mg/l or containing substances which reach a viscosity of fifty-five (55) cps at twenty-five (25) degrees Celsius. (5) Any garbage that has not been properly shredded. The installation and operation of any garbage grinder equipped with a motor of ¾ horsepower (0.76 hp metric) or greater shall be subject to the review and approval of the city engineer. (6) Any waters or wastes containing strong acid iron pickling wastes, or concentrated plating solutions whether neutralized or not. (7) Any waters or wastes containing iron, chromium, copper, zinc, and similar objectionable or toxic substances; or wastes exerting an excessive chlorine requirement, to such degree that any such material received in the composite sewage at the wastewater treatment works exceeds the limits established by the city engineer for such materials. (For industrial process wastes, see section 25-117.) (8) Any waters or wastes containing phenols or other taste or odor-producing substances, in such concentrations exceeding limits which may be established by the city engineer as necessary, after treatment of the composite wastewater, to meet the requirements of the state, federal, or other public agencies of jurisdiction for such discharge to the receiving waters. (9) Any radioactive wastes or isotopes of such half-life or concentration as may exceed limits established by the city engineer in compliance with applicable state or federal regulations. (10) Any waters or wastes having a pH in excess of 9 or below 6.0. (11) Materials which exert or cause: a. Unusual concentrations of inert suspended solids (such as, but not limited to, Fullers earth, lime slurries, and lime residues) or of dissolved solids (such as, but not limited to, sodium chloride and sodium sulfate). b. Excessive discoloration (such as, but not limited to, dye wastes and vegetable tanning solutions). c. Unusual BOD, chemical oxygen demand, or chlorine requirements in such quantities as to constitute a significant load on the wastewater treatment works. d. Any pollutant, including oxygen demanding pollutants (BOD, etc.) released at a flow rate and/or pollutant concentration which a user knows or has reason to suspect will cause interference to the wastewater treatment works. In no case shall a slug load have a flow rate or contain concentration or qualities of pollutants that exceed for any time period longer than fifteen (15) minutes more than five (5) times the average twenty-four-hour concentration, quantities, or flow during normal operation. (12) Waters or wastes containing substances which are not amenable to treatment or reduction by the wastewater treatment processes employed, or are amenable to treatment only to such degree that the wastewater treatment plant effluent cannot meet the requirements of other agencies having jurisdiction over discharge to the receiving waters. (13) Any waste prohibited by environmental protection agency standards as set out in the United States Code of Federal Regulations, Title 40, Part 403.
(Ord. No. 3691, Art. V, § 4, 5-1-84; Ord. No. 4575, 6-20-23)
Ask a question about Meridian law
Corpus searches the Meridian sections it holds and shows the ones that match, with their citations. Free, no sign-in.
