Stables and assembly/transfer facilities.
Minneapolis Code of Ordinances § 63.150
in effect63.150. - Stables and assembly/transfer facilities.
(a) A stable or assembly/transfer facility may be operated in the city of Minneapolis only in strict compliance with all of the requirements set forth in this section.
(b) Compliance with zoning code. A stable or assembly/transfer facility shall comply with all applicable provisions of the zoning code and any conditional use permit or other applicable land use approval granted by the city council pursuant to the zoning code.
(c) Stable and assembly/transfer facility to be used exclusively for licensed horse and carriage livery service.
(1) A stable or assembly/transfer facility shall be used exclusively for the purpose of keeping horses used in a horse and carriage livery service licensed under Chapter 303 of this Code.
(2) No horse shall be stabled or otherwise kept in a stable or assembly/transfer facility unless it is registered with the licensing official pursuant to section 303.80 of this Code.
(3) Each horse shall meet the requirements in Chapter 303 of this Code, and any other applicable local, state, or federal law for veterinary examination and certification and care and maintenance of animals.
(d) Stable construction.
(1) Interior stable walls shall be smooth, light colored and sealed, and shall be constructed of a material that is easily cleaned such as gloss finished block, gloss or semi-gloss painted concrete, or an equivalent material.
(2) Floors, gutters, and all areas within the stable grounds where horses traverse or stand shall be constructed of good quality concrete or other firm, nonporous and nonslip material which is sloped to drain and is maintained in good repair. Interior floor-to-wall junctures shall be covered and watertight.
(3) If rubber mats are used as a floor covering, they shall be nonabsorbent and easily removable for cleaning.
(4) Stall partitions shall be wooden plank, metal bars, pipe paneling, or other similar material of sufficient thickness and strength to properly contain the animals therein. Solid partitions such as concrete, or a minimum of ten (10) gauge sheet metal paneling, may be used if adequate ventilation is maintained.
(5) Tie stalls shall be wide enough to allow a horse to comfortably lie down. Box stalls shall be at least ten (10) feet square.
(6) Watering devices shall protect against possible backflow of water into the water supply system. The system shall be grounded to prevent stray voltage.
(7) A ventilation system is required which shall provide sufficient air circulation and exhaust to minimize odors and condensation on walls and ceilings. Mechanical ventilation must be provided to meet these criteria.
(8) Windows and other exterior openings shall be screened to minimize the entrance of insects and rodents. Screen doors shall be utilized if doorways are to be used for ventilation.
(9) At least ten (10) foot-candles of light shall be available throughout the stable to allow for effective cleaning.
(10) Toilet and hand washing facilities shall be provided for the convenience of stable workers. Hand washing facilities shall consist of a sink with hot and cold water, soap, and single use towels.
(11) A utility sink or a curb cleaning facility with a floor drain shall be provided for janitorial purposes. It is to be supplied with hot and cold running water. The faucet shall be protected against possible water backflow.
(12) A telephone shall be readily accessible on the premises for making emergency calls.
(e) Stable operation.
(1) Only one (1) horse may be in a stall and the stable shall not contain any more horses than it has stall space to accommodate.
(2) Only city registered horses may be present in the stable unless prior approval has been granted by MACC.
(3) Water shall be available for horses at all times when they are in their stalls.
(4) If horses are to be tethered, they shall be tethered by a halter.
(5) Odors and condensation shall be kept to a minimum.
(6) The stable, including equipment and furnishings, shall be kept in good condition.
(7) To prevent harborage or breeding of insects and rodents, the stable interior and surrounding property shall be kept neat and free of litter and clutter.
(8) Effective pest control measures emphasizing preventative action shall be provided to prevent insect and rodent pests from being present in the stable or on stable property.
(9) Feed shall be stored in rodent proof facilities or containers.
(10) Straw, shavings, or other bedding material shall be kept clean and dry and shall be changed as often as is necessary to keep it in that condition.
(11) Manure, soiled bedding, barn sweepings, and waste feed shall be removed from the premises twice a week. When stored prior to removal, these materials shall be kept in insect and rodent proof facilities or containers.
(12) A person who is capable of handling horses routinely and in emergencies shall be at the stable at all times when horses are on the premises.
(13) Smoking shall not be allowed in stabling or storage areas.
(f) Assembly/transfer facility construction.
(1) The facility may consist of either an impervious concrete slab floor, or other firm, nonporous, and nonslip footing, which is sloped to a drainage system and is curbed at the sides. The facility shall be sufficient to contain all wastes and spillage.
(2) Overhead protection from sun and sleet and other precipitation shall be provided for horses when necessary.
(3) There shall be an adequate means to tether or contain all horses.
(4) Toilet and hand washing facilities for workers shall be present or available close by.
(5) At least ten (10) foot-candles of light shall be provided throughout the facility whenever it is being used.
(6) Any additional structures, equipment, or furnishings that are provided shall meet the applicable standards for stables.
(g) Assembly/transfer facility operation.
(1) The facility shall only be occupied by horses within a daily eighteen (18) hour time period. That time period shall be stated in writing by the licensee at the time the application is submitted for licensure.
(2) Only city registered horses may be present unless prior approval has been granted by MACC.
(3) Clean and potable drinking water shall be provided to the horses according to their need while they are at the facility.
(4) If horses are to be tethered, they shall be tethered by a halter.
(5) The facility, including equipment and fixtures, shall be maintained clean and in good condition at all times and odors shall be kept to a minimum.
(6) All feed and wastes shall be stored in secure rodent-proof containers. Waste feed and manure shall be removed daily.
(7) Effective insect control measures shall be utilized at the site.
(8) A person who is capable of handling horses routinely and in emergencies shall be at the facility at all times when horses are present.
(h) Other provisions of law unaffected. Nothing herein shall be construed to exempt a stable or assembly/transfer facility from other applicable laws relating to health or safety, nor to limit the lawful enforcement powers of any public agency, official, or employee. (Ord. No. 2016-009, § 1, 2-12-16)
Source: City of Minneapolis, Minnesota, Code of Ordinances, City Charter and Park and Recreation Board Code of Ordinances (Municode Library, library.municode.com)URL: https://library.municode.com/mn/minneapolis/codes/code_of_ordinances?nodeId=COOR_TIT4ANCACO_CH63LIPE_63.150STASTRFAFetched: 11/2/2026
