For AI agents: read the machine-readable documentation index at /llms.txt or the single-file full reference at /llms-full.txt.

§ 61.302 — Detached Single Family, Duplex or Townhome Dwelling Units

Code of the City of Orlando (Supp. No. 93, Update 1: codified through Ordinance No. 2026-10, adopted April 6, 2026) · Orlando City Code § 61.302

Corpus is an independent public-information project, not the official City of Orlando website. Stable reference: corpuslaw.us/code/621638ca-0ad1-498a-a181-236b516b591a

Sec. 61.302. - Detached Single Family, Duplex or Townhome Dwelling Units.

The parking requirements of this Part are intended to provide minimum standards necessary for the parking needs of the low density residential uses. These regulations apply to single family detached houses, duplexes, tandem houses, and attached townhomes (regardless of the number of units attached in a single run) which are sold on fee simple lots or as a part of a condominium association. Unless noted otherwise below, these regulations apply throughout the City of Orlando. (A) Required Parking Spaces. Each dwelling unit must provide one (1) off-street parking space behind the front and street side yard setback that conforms to the following: (1) Dimensions: a. Uncovered Parking Space. A required parking space shall be a minimum of 9 feet wide and 18.5 feet deep for an open parking space. This minimum width must be increased by 1 foot if the space abuts a lateral obstruction such as a building exterior wall or a fence. b. Garages and Carports. The minimum garage and carport interior dimensions for required parking spaces are: (as measured from the internal walls of a garage) • One-car: 11 feet wide and 20 feet deep • Two-car: 19 feet wide and 20 feet deep Note: The required width of a carport space may be reduced by 1 foot if no wall interferes with the door swing. (2) Setbacks. All required parking spaces must be located behind the front setback and 20 ft. from the street side property line. Any second required parking space may not be in a stacked or tandem configuration. (B) Additional Parking / Vehicle Use Areas in the front and street side yards. Parking and driveways (vehicle use area) within the required front and street side yards setbacks shall conform to the following: (1) Overlap - No portion of vehicle use areas may be in the area where the front yard and the street side yard overlap. (2) Parallel - Parking areas in the required front and street side yards must be parallel to the driveway. (C) Driveways. (1) Width. The width of the driveway measured at the front or street side property line shall be between a minimum of 7 feet and a maximum of 18 feet and meet all requirements and limitations in Section 61.240 including the prohibition of "tuning fork" style driveways for duplexes and tandems. The width shall be measured parallel to the right-of-way line and must match the width of the apron at the property line. The driveway may be expanded past the property line but must be tapered at a minimum 45 degree angle. (2) Walkways - Walkways parallel to the driveway must be separated from the driveway by a minimum 2 ft. wide strip of ground cover or other landscaping. Gravel may not be incorporated into a walkway within 15 ft. of the property line. Walkways not separated from the driveway by the 2 ft. strip will be included in the driveway width measurement. (3) Setbacks - No vehicular use surface may be closer than 2 ft. from any side or rear property line unless such driveway straddles a property line, is designed to serve both adjacent residential properties, and is within a legally recorded easement to the benefit of both property owners. (4) Intersection Separation - The distance of the driveway apron from an intersection must comply with the standards set forth in Chapter 61, Sections 212 to 213; Chapter 61, Figure 1; and the Engineering Standards Manual. (5) Aprons - Each driveway must terminate at the street with an approved apron. Said apron must have a 3 ft. flare and must be separated at least 1 ft. from the extended property line. Figure 6-D - One- and Two-Family Residential Driveway [image omitted; see the official code] (D) Semi-Circular Driveways and Secondary Curbcuts. (1) Lot frontages on Arterial Streets listed in Table 3 of Chapter 61 Part 2B may not have 2 curbcuts or semi-circular driveways on the same street. Corner lots may have no more than 1 curb cut on each abutting street. (2) Lot frontages within a designated historical district may not have 2 curbcuts or semi-circular driveways on the same street. Corner lots may have no more than 1 curb cut on each abutting street. (3) Semi-circular driveways served by 2 curbcuts are permitted on interior lots with a minimum of 65 feet of frontage that access a Local Street. Interior lot frontages on Collector Streets listed in Table 3 of Chapter 61, Part 2B may only have 2 curbcuts or semi-circular driveways if the frontage is a minimum of 100 feet wide. (4) Semi-circular driveways served by 2 curbcuts are permitted on corner lots on a side with a minimum frontage of 100 feet that access a Local Street. The outside edge of the driveway must be a minimum of 50 feet from the back of curb or outside edge of pavement of the intersecting street measured at the property line. Two curbcuts accessing the same street are not permitted on Collector Streets listed in Table 3 of Chapter 61 Part 2B on corner lots. (5) The cumulative widths of the 2 driveways on one street may not exceed 26 feet as measured at the property line. (6) The curved portion of any semi-circular driveway must be designed to create a minimum of 5 feet between the inner edge of the driveway and the front property line. This area must be screened from the right-of-way by shrubs or a hedge. Vegetative screening material shall be maintained by the property owner. (7) No single family detached lots may have 2 curbcuts accessing the same street unless the 2 curbcuts are connected by a paved and traversable driveway. Tandem lots and duplex lots may have 2 unconnected curbcuts if the lots meet the minimum widths outlined above. Figure 6-E - One- and Two-Family Residential Semi-Circular Driveway [image omitted; see the official code] (E) Surface (1) The parking spaces and the driveway must be on an impervious surface such as asphalt, concrete, brick, or engineered turf pavers. The space may be outdoors, under cover, or within an enclosed garage. (2) Gravel. Gravel or stone may not be used for any part of a driveway or parking space in a residential property including as filler between the ribbons of a driveway. Subject to engineering permit review, stone on existing stone driveways may be replenished as long as the existing driveway dimensions are maintained. Existing non-conforming stone vehicular use areas must be maintained per City engineering standards. (3) All parking spaces must be accessible from the front, rear, or side street via a paved surface and approved curb cut and driveway apron. (F) Impervious Surface Ratio. The total impervious surface ratio of the required front or street side yard setbacks may not exceed 0.40 for any driveway, parking, or turn around configuration. Calculation of the impervious surface ratio must include any non-vehicular impervious areas such as patios but shall not include sidewalks in City Services or Sidewalk Easements or other surfaces exempted from this calculation by other sections of this Code. (G) Garage setbacks. The façade of any garage or carport accessed from a side street must be a minimum of 20 feet behind the property line regardless of the street-side yard setback required for the Zoning District. (H) Alley Loaded. The facade of any garage or carport accessed from an alley may be placed 5 feet or less or at least 20 feet behind the rear property line. (Facades may not be 6 to 19 feet from the property line). Parking spaces created in the street side or rear yard without garages or carports must be a minimum of 20 feet long as measured from the property line. (I) Sightlines. Landscaping, fences, or other structures near driveways and parking spaces may not impede the sightline of drivers maneuvering into and out of the adjacent rights of way. This includes sightlines for pedestrians and bicyclists who might be using the sidewalks along the property. This requirement applies to newly planted and established landscaping. Property owners are responsible for trimming and maintaining any landscaping to ensure adequate sightlines are maintained. The specific details for location and size of objects placed near driveways may be found in the latest edition of the Engineering Standards Manual. (J) Parking in Non-Designated Areas Prohibited. Parking or storage of vehicles shall be prohibited on any portion of the building site except on those areas which have been specifically permitted and constructed as parking spaces or vehicular use areas. Example driveway and parking configurations that meet this Code for various contexts can be found in the City's "Guideline for Residential Driveways" maintained by the City Planning Division.

(Ord. No. 2010-33, § 1, 8-30-2010, Doc. #1008301102; Ord. No. 2017-17, § 9, 4-10-2017, Doc. #1704101203; Ord. No. 2018-44, § 6, 9-4-2018, Doc. #1809041202; Ord. No. 2019-10, § 1, 3-25-2019, Doc. #1903251201; Ord. No. 2022-45, § 3, 8-15-2022, Doc. #2208151209)

Ask a question about Orlando law

Corpus searches the Orlando sections it holds and shows the ones that match, with their citations. Free, no sign-in.