11-25-4: - DEVELOPMENT STANDARDS FOR BILLBOARDS
A. General Development Standards.
1. Billboards are required to comply with A.R.S. Title 28, Chapter 23, Article 1, and the development standards established in this Chapter.
2. No deviations from the development standards identified in this Chapter are permitted unless the deviation is more restrictive.
3. For all other land uses on the site, compliance with the specific development standards for the underlying base zoning district is required and cannot be modified through the Billboard Overlay District.
B. Setback Requirements. Setbacks for Billboards must adhere to the standards of the underlying base zoning district except for setbacks from the Freeway, in which the following setbacks shall apply:
1. Minimum Setback from Freeway. The minimum setback to a Freeway right-of-way is zero (0) feet, distance measured from the nearest edge of the Billboard face to the nearest edge of the Freeway right-of-way.
2. Maximum Setback from Freeway. A Billboard must be located within 250 feet of a Freeway right-of-way, distance measured from the furthest edge of the Billboard face to the nearest edge of the Freeway right-of-way.
3. Encroachment into Right-of-Way Prohibited. No portion of a Billboard shall overhang or encroach into the right-of-way.
C. Spacing Requirements.
1. Billboards or Freeway Landmark Monuments. No portion of a Billboard may be placed within 1,000 feet of another Billboard or Freeway Landmark Monument, including Billboards and Freeway Landmark Monuments located in neighboring jurisdictions, distance measured from the nearest edge of the Billboard face to the nearest edge of the nearest Billboard face or Freeway Landmark Monument face.
2. Residential Zoning District or Residential Use. No portion of a Billboard may be placed within 500 feet of a Residential Zoning District (RS, RSL, or RM) or residential use unless:
A. The residential use is part of a mixed-use development; or
B. A line-of-sight study or balloon test is conducted and demonstrates the Billboard will not be visible to or from any residential use that is not part of a mixed-use development or residential zoning district within 500 feet.
C. In no case may any portion of the Billboard be placed within 400 feet of a residential use that is not part of a mixed-use development or a residential zoning district.
D. Number and Size Requirements.
1. Maximum Number. No more than two (2) Billboards are permitted within a Billboard Overlay District.
2. Billboard Sign Area.
a. Maximum Sign Area. The maximum sign area of a Billboard is limited to 672 square feet per sign face.
b. Sign Area Dimensions. The maximum vertical dimension of a Billboard's sign face is fourteen (14) feet and the maximum horizontal dimension of a Billboard's sign face is forty-eight (48) feet.
c. Back-to-Back. Back-to-Back are permitted with the maximum sign area allowed for each face as shown on Figure 11-25-4.C.2.
d. "V" Shaped Billboards.
i. A Billboard may be "V" shaped, provided the interior angle between the two sign faces is forty-five (45) degrees or less.
ii. If the angle between the two (2) sign faces is greater than forty- five (45) degrees, the sign area is the sum of the areas of the two (2) sign faces as shown on Figure 11-25-4.C.2.
[image omitted; see the official code]
e. Embellishments. A Billboard's maximum sign area may be exceeded by up to 20% by a Billboard embellishment.
f. Standards of Measurement for Billboards and Embellishments. Billboards and embellishments shall be measured by the smallest square, rectangle, triangle, circle or combination of the smallest square, rectangle, triangle, or circle that will encompass the entire Billboard or the entire embellishment, excluding base or apron supports, pylons, and other structural parts.
3. Billboard Height.
a. The maximum height of a Billboard, including any supporting structures, attachments, and embellishments, shall not exceed 60 feet.
b. Height measurement.
i. If the natural grade at the base of a Billboard is higher than, or at the same grade as the Freeway, the Billboard height shall be measured as the vertical distance from the average elevation of the natural grade within a 50-foot radius from all sides of the Billboard base to the highest point of the Billboard.
ii. If natural grade at the base of a Billboard is lower than the grade of the Freeway or has been reduced to provide a storm water retention basin, the height of the Billboard shall be measured from the Freeway elevation to the highest point of the Billboard.
E. Auditory Effects. Auditory effects, including music, are prohibited as part of any Billboard.
F. Electronic Billboard Requirements. Electronic Billboards must comply with the following:
1. Copy Change. Copy must not change more than once every eight (8) seconds.
2. Message Animation.
a. Animation, video, flashing, blinking, or moving lights are prohibited.
b. In the transition between copy, there must not be any sense of movement from one message to the next.
3. Malfunction. An electronic Billboard must contain a default design mechanism that freezes copy in one (1) position if a malfunction occurs.
G. Lighting Controls.
1. Electronic Billboards.
a. Evening Illumination. Illumination of electronic Billboards must not exceed 300 nits in full white mode in evening hours (from sunset until 11:00 p.m.).
b. Automatic Dimming. Electronic message panels must include automatic lighting control technology to dim, control, and vary the intensity of the display based on ambient light conditions (e.g. daytime, nighttime, partial shade, or cloudy conditions) through a photoelectric sensor that detects ambient light levels and automatically adjusts the display intensity to ensure compliance with the maximum nit levels in this Section.
2. Nighttime Illumination. All electronic and non-electronic Billboard illumination must be extinguished in nighttime hours (from 11:00 p.m. until sunrise), except for amber alerts and emergency messaging.
(Ord. No. 5847, § 1, 3-4-24; Ord. No. 5889, §§ 1, 2, 11-4-24)