City Tree Matrix; technical standards; authority to establish, publish, and adopt.
Tampa City Code § 27-284.1.1
in effectSec. 27-284.1.1. - City Tree Matrix; technical standards; authority to establish, publish, and adopt.
(a) City Tree Matrix. Refer to section 27-284.3.2.
(b) The technical standards set forth in the "City of Tampa's Tree and Landscape Technical Manual," ["Technical Manual"], on file in the office of the city clerk, is adopted herein by reference, and shall have the force and effect of law. The Technical Manual sets forth standards that include:
(1) Tree mitigation method reference tables (refer to section 27-284.4.1 for mitigation method, Tree Retention-Mitigation Equivalency Tables, and applicable permit procedures);
(2) Tree condition and risk evaluation form (refer to subsection (c) below for general evaluation criteria);
(3) Tree installation methods with related graphics;
(4) Tree protection methods during construction with related graphics;
(5) Example tree and landscape plans with related, supplemental graphics;
(6) List of tree, landscape, and forestry reference materials.
(c) Tree condition and risk evaluation criteria. The typical criteria, used by the city for evaluation of a tree's condition and risk factors, are as follows (refer to Technical Manual for applicable form):
(1) Condition rating of tree roots, tree trunk, tree limbs/branch structure, twigs, and foliage:
a. A: Excellent/No apparent problem.
b. B: Good/Minor problem.
c. C: Fair/Major problem.
d. D: Poor/Extreme problems.
e. F: Dead.
(2) Risk evaluation for failure potential, size of defective part, rating of potential target at risk if failure occurs:
a. Failure potential (up to four (4) points). Failure potential identifies the most likely failure and rates the likelihood that the structural defects(s) will result in failure within the inspection period. Examples of ratings are:
1. Low (one (1) point): Defects are minor (e.g. dieback of twigs, small wounds with good woundwood development).
2. Medium (two (2) points): Defects are present and obvious (e.g. cavity encompassing ten (10) to twenty-five (25) percent of the circumference of the trunk, co-dominant stems without included bark).
3. High (three (3) points): Numerous and/or significant defects present (e.g. cavity encompassing thirty (30) to fifty (50) percent of the circumference of the trunk, multiple pruning wounds with decay along a branch).
4. Severe (four (4) points): Defects are very severe (e.g. heartrot, decay conks along the main stem. Cavity encompassing more than fifty (50) percent of the trunk.
b. Size of defective part (up to four (4) points). Size of defective part rates the size of the part most likely to fail. The larger the part that fails, the greater the potential for damage. Therefore, the size of the failure affects the hazard potential. Examples are:
1. (One (1) point) Most likely failure less than six (6) inches (fifteen (15) cm) in diameter.
2. (Two (2) points) Most likely failure six (6) to eighteen (18) inches (fifteen (15) to forty-five (45) cm) in diameter.
3. (Three (3) points) Most likely failure eighteen (18) to thirty (30) inches (forty-five (45) to seventy-five (75) cm) in diameter.
4. (Four (4) points) Most likely failure greater than thirty (30) inches (seventy-five (75) cm) in diameter.
c. Target rating (up to four (4) points). Target rating rates the use and occupancy of the area.
1. Occasional use (one (1) point): (e.g. jogging/cycling trial).
2. Intermittent use (two (2) points): (e.g. picnic area, day-use parking).
3. Frequent-use secondary structure or area (three (3) points): (e.g. seasonal camping area, storage facilities).
4. Constant-use primary structures (four (4) points): (e.g. year-round use for a number of hours each day, residences).
(3) The points in each category are added to obtain the overall hazard rating, with twelve (12) being the maximum value, expressed in the following formula: "Risk/Hazard Rating = Failure Potential + Size of Part + Target Rating"
(4) The assignment of a rating is made with three (3) considerations in mind:
a. Length of evaluation cycle.
b. Level of resolution required by the goals of the hazard management program.
c. Past history and rating.
(5) If records are not available and not employed in the process, then the rating reflects only one (1) moment in time, rather than the long-term development of the tree.
(6) Ratings have only relative meaning (i.e. a tree rated an 11 has a greater hazard potential than one rated a 5.) By description, a tree rated a 12 represents a significant hazard, but abating this hazard could be as simple as removing the defect and/or the target.
(Ord. No. 2019-54, § 33(Exh. A), 4-18-2019)
Source: City of Tampa, Code of Ordinances and Charter and Related Laws (Municode Library, library.municode.com)URL: https://library.municode.com/fl/tampa/codes/code_of_ordinances?nodeId=COOR_CH27ZOLADE_ARTVISURE_DIV4NARETRLAWEUPHA_SD1GEPR_S27-284.1.1CITRMATESTAUESPUADFetched: 10/28/2026
