Rules of measurement.
Tulsa Revised Ordinances tit. 42, § 60.130
in effectSection 60.130. - Rules of measurement.
A. Sign area.
1. Signs enclosed in frames or cabinets. The area of a sign enclosed in a frame or cabinet is determined based on the outer dimensions of the frame or cabinet surrounding the sign face (see Figure 60-2).
Figure 60-2: Sign Area Measurement (Signs in Cabinets or Frames)
[image omitted; see the official code]
2. Channel (individual) letter signs.
a. The area of a sign comprised of individual letters or elements attached to a building wall is determined by calculating the area of the smallest geometric figure (e.g. square, rectangle, circle, polygon, etc.) that can be drawn around the letters and/or elements (see Figure 60-3).
b. Signs consisting of individual letters and/or elements will be measured as one sign when the distance between the letters and/or elements is less than the largest dimension of the largest sign letter (see Figure 60-4).
Figure 60-3: Sign Area Measurement (Individual Letter Signs)
[image omitted; see the official code]
Figure 60-4: Sign Area Measurement (Single vs. Multiple Signs)
[image omitted; see the official code]
3. Multi-sided signs. Unless otherwise expressly stated, when the sign faces of a multi-sided sign are parallel or within thirty (30) degrees of parallel, only one side is counted for the purpose of determining the area and number of signs. If the sign faces are not parallel or within thirty (30) degrees of parallel, all sign faces are counted (see Figure 60-5).
Figure 60-5: Multi-Sided Signs
[image omitted; see the official code]
4. Non-planar signs. Spherical, free-form, sculptural or other non-planar sign area is measured as fifty (50) percent of the sum of the areas using only the four (4) vertical sides of the smallest four-sided polyhedron that will encompass the sign structure. Signs with greater than four (4) polyhedron faces are prohibited.
Figure 60-6: Non-Planar Sign Measurement
[image omitted; see the official code]
B. Sign height. The height of a sign is measured as the vertical distance from curb level to the highest point of the sign.
Figure 60-7: Sign Height Measurement
[image omitted; see the official code]
C. Setback, spacing and separation distances.
1. Required setback, spacing and separation distances between signs must be measured in a straight line from the nearest points on the respective sign structures. Required separation distances between signs and zoning districts, area or lots must be measured in a straight line from the nearest point on the sign structure to the nearest point of the subject district, area or lot.
2. The required separation distance between off-premise outdoor advertising signs must be measured in a straight line from the center of the respective off-premise outdoor advertising sign structures, as located on the ground.
D. Illumination and luminance.
1. Foot-candles. Sign illumination in foot-candles is measured two (2) feet from the sign face.
2. Nits. For the purpose of verifying compliance with maximum brightness level limits expressed in "nits," brightness levels must be measured with the dynamic display set to run full white copy with a luminance meter positioned at a location perpendicular to the sign face center. When taking the luminance reading, the sign face must be the only subject visible in the viewfinder.
E. Window area. The area of a window includes only the glass or glazed elements of the window. Frames, mullions and similar features are not counted as part of the window area (see Figure 60-8).
Figure 60-8: Measurement of Window Area
[image omitted; see the official code]
Source: City of Tulsa, Revised Ordinances and City Charter (Municode Library, library.municode.com)URL: https://library.municode.com/ok/tulsa/codes/code_of_ordinances?nodeId=COOR_TIT42ZOCO_CH60SI_S60.130RUMEFetched: 10/28/2026
