23.04.320 - Signs on residential parcels.
A. Quantity.
1. Subject to Subsections 23.04.320.A.2 and A.3 below, one attached or freestanding sign shall be allowed on each residential parcel.
2. For residential developments consisting of at least one building with one hundred residential units or more, two attached signs or two freestanding signs or a combination of one attached sign and one freestanding sign shall be allowed for each frontage on a public street.
3. For each residential development consisting of more than two thousand residential units and located on fifty or more acres, one additional freestanding sign shall be allowed for each frontage of the single residential development on a public street consisting of at least four moving travel lanes and identified on the general plan transportation diagram at the time the sign was approved.
B. Size.
1. The aggregate sign area of all attached and freestanding signs allowed under this section shall not exceed one square foot of sign area for each occupancy unit on the parcel, except as otherwise allowed in this part.
2. Each individual sign shall not exceed a maximum of thirty-two square feet in size, except as otherwise allowed in this part.
3. Unless otherwise specified in this part, signage for residential developments consisting of at least one building with one hundred residential units or more shall be subject to the following:
a. The sign area for each attached sign shall not exceed thirty-two square feet; and
b. Freestanding signs shall not exceed one square foot of sign area for each eight linear feet of street frontage, up to a maximum of thirty-two square feet in sign area.
C. Height.
1. Attached signs shall not be displayed higher than twelve feet above grade, except for skyline signs, residential developments consisting of at least one building one hundred units or more, and awning signs as indicated in this part.
2. Subject to Section 23.04.320.C.3 below, freestanding signs shall not be more than three feet in height and shall not be located more than five feet from the primary residential building.
3. For residential developments consisting of at least one building with one hundred residential units or more:
a. Attached signs shall be displayed no greater than thirty feet in height above grade.
b. An attached sign may be displayed over, under or on a permanent projecting canopy that is architecturally integrated with the design of the building, subject to the following:
i. Both an attached sign and an awning sign shall not be placed on the same permanent projecting canopy.
ii. If the attached sign is located under a permanent projecting canopy, such sign shall be displayed at least seven feet above grade.
c. Freestanding signs shall be allowed up to five feet in height for each fifty units located on the subject site. The maximum height of a freestanding sign shall be no greater than fifteen feet above grade, except in the North San José signage area where the maximum height of a freestanding sign shall be no greater than twenty feet above grade.
D. Setbacks.
1. Freestanding signs shall be located at least twenty-five feet from the side and rear property lines of the parcel.
2. In the case of parcels less than fifty feet wide, signs shall be located as far from the side property lines of the parcel as possible.
3. Freestanding signs shall be set back a minimum of ten feet from the front property line of the parcel, except:
a. For residential developments consisting of at least one building with one hundred residential units or more, freestanding signs shall be set back a minimum of seven feet from the front property line of the parcel.
4. Freestanding signs shall be separated by a distance of at least ten feet from each other unless otherwise provided in this section.
E. Other types of signs. The following types of signage shall be allowed and shall not reduce the types and quantity of signage that are otherwise allowed under this part.
1. Skyline signs. Residential or mixed-use residential buildings one hundred forty feet to one hundred ninety feet in height above grade may have one skyline sign in addition to other allowable signage for the building or the parcel, subject to the following provisions:
a. The total sign area for the skyline sign shall not exceed two hundred fifty square feet of signage.
b. Each skyline sign shall be designed and constructed as an integral part of the building and placed on a permanent architectural element that has been designed and constructed to accommodate such signage.
c. The skyline sign shall not illuminate or be mounted on the exterior of that portion of the building facade containing residential living units.
2. Awning signs. Residential developments consisting of at least one building with one hundred residential units or more may have awning signs subject to the following provisions:
a. A maximum of two awning signs per building frontage may be placed upon each discrete surface of an awning.
b. Each awning sign shall be no greater than ten square feet in sign area.
c. Awning signs shall be located at least seven feet but no greater than twelve feet in height above grade.
d. Awning signs shall maintain a minimum three-inch clearance from each edge of the discrete surface of the awning on which the sign is placed.
3. Window signs. Window signs in conformance with Section 23.02.1060 of this title shall be allowed.
F. Other provisions.
1. Window, awning, projecting and segmented signs shall not be allowed unless otherwise specified in this part.
2. Signs shall not be displayed on accessory structures.
3. Illumination:
a. Signs shall not be illuminated, except for required safety or directional signs, or as otherwise allowed in this part.
b. Signs located within one hundred feet of a riparian corridor shall not be illuminated.
c. Signs on residential developments consisting of at least one building with one hundred residential units or more may be illuminated with external lighting, halolighting, and internal lighting if only the letters or symbols are illuminated. Such signs shall be illuminated only with continuous lighting.
d. Subject to Subsection E.1.c of this Section 23.04.320, skyline signs may be illuminated with external lighting, halolighting, and internal lighting if only the sign area is illuminated. Such signs shall be illuminated only with continuous lighting, except that gradual color changes shall be allowed if there is no perception of flashing lights created.
(Ords. 24201, 26273, 29097, 29380, 29558.)