§ 19.620.070 — General provisions for all sign types
Riverside Municipal Code (Supp. No. 33: codified through Ordinance No. 7776, enacted June 23, 2026) · Riverside Municipal Code § 19.620.070
Corpus is an independent public-information project, not the official City of Riverside website. Stable reference: corpuslaw.us/code/a387701c-2d28-4cf8-9428-338bf9539a43
19.620.070 - General provisions for all sign types.
The following regulations apply to all signs in any zone: A. Signs must comply with this Code. In all zones, only such signs as are specifically permitted in this chapter may be placed, erected, maintained, displayed or used, and the placement, erection, maintenance, display or use of signs shall be subject to all restrictions, limitations and regulations contained in this chapter. The placement, erection, maintenance, display or use of all other signs is prohibited. B. Enforcement authority. The Community & Economic Development Director or his/her designee is authorized and directed to enforce and administer the provisions of this chapter. C. Permit requirement. Unless expressly exempted by a provision of this chapter, or by other applicable law, signs within the regulatory scope of this chapter may be displayed only pursuant to a permit issued by the City pursuant to Section 19.620.100 of this chapter and any applicable permit required by the Building Code. D. Design review required for nonresidential uses. Unless exempt from the requirements of this chapter, the design and placement of any permanent sign erected for a nonresidential use is subject to review under the Citywide Sign and Design Guidelines. E. Message neutrality. It is the City's policy to regulate signs in a constitutional manner that does not favor commercial speech over noncommercial speech and is content neutral as to noncommercial messages which are within the protections of the First Amendment to the U.S. Constitution and the corollary provisions of the California Constitution. F. Regulatory interpretations. All regulatory interpretations of this chapter are to be exercised in light of the City's message neutrality policy. Where a particular type of sign is proposed in a permit application, and the type is neither expressly allowed nor prohibited by this chapter, or whenever a sign does not qualify as a "structure" as defined in the Building Code, then the Community & Economic Development Director or his/her designee shall approve, conditionally approve or disapprove the application based on the most similar sign type that is expressly regulated by this chapter. G. Changes to copy of approved signs. Changes to the copy of approved signs that were legally established and have not been modified so as to become illegal are exempt from permitting pursuant to this chapter. Changes to copy do not include changes to the type or level of illumination of an approved sign. H. Substitution of messages. Subject to the property owner's consent, a protected noncommercial message of any type may be substituted for any duly permitted or allowed commercial message or any duly permitted or allowed noncommercial message, provided that the sign structure or mounting device is legal without consideration of message content. Such substitution of message may be made without any additional approval or permitting. This provision prevails over any more specific provision to the contrary within this chapter. The purpose of this provision is to prevent any inadvertent favoring of commercial speech over protected noncommercial speech, or favoring of any particular noncommercial message over any other noncommercial message. This provision does not create a right to increase the total amount of signage on a parcel, lot or land use; does not affect the requirement that a sign structure or mounting device be properly permitted; does not allow a change in the physical structure of a sign or its mounting device; does not allow the substitution of an off-site commercial message in place of an on-site commercial message. I. Rules for non-communicative aspects of signs. All rules and regulations concerning the non-communicative aspects of signs, such as location, size, height, illumination, spacing, orientation, etc., stand enforceable independently of any permit or approval process. J. Situs of non-commercial message signs. The onsite/offsite distinction applies only to commercial messages on signs. K. Mixed Use Zones. In any zone where both residential and nonresidential uses are allowed, the sign-related rights and responsibilities applicable to any particular use shall be determined as follows: residential uses shall be treated as if they were located where that type of use would be allowed as a matter of right, and nonresidential uses shall be treated as if they were located in a zone where that particular use would be allowed, either as a matter of right or subject to a conditional use permit or similar discretionary process. L. Property owner's consent. No sign may be displayed without the consent of the legal owner(s) of the property on which the sign is mounted or displayed. For purposes of this policy, "owner" means the holder of the legal title to the property and all parties and persons holding a present right to possession, control or use of the property. M. Legal nature of signage rights and duties. As to all signs attached to property, real or personal, the signage rights, duties and obligations arising from this chapter attach to and travel with the land or other property on which a sign is mounted or displayed. This provision does not modify or affect the law of fixtures, sign-related provisions in private leases regarding signs (so long as they are not in conflict with this chapter), or the ownership of sign structures. N. Variances. 1. When a variance from the rules stated in this chapter is sought, such variance may be permitted only upon the approval of the Approving Authority as designated in Table 19.650.020 and pursuant to the procedures set forth in Chapter 19.720 (Variance). 2. In considering requests for such variances, the Approving Authority shall not consider the message of the sign display face. 3. No variance that would allow a permanent structure sign to be used for the display of off-site commercial messages or general advertising for hire may be approved. O. Severance. If any section, sentence, clause, phrase, word, portion or provision of this chapter is held invalid or, unconstitutional, or unenforceable, by any court of competent jurisdiction, such holding shall not affect, impair, or invalidate any other section, sentence, clause, phrase, word, portion, or provision of this chapter which can be given effect without the invalid portion. In adopting this chapter, the City Council affirmatively declares that it would have approved and adopted the Chapter even without any portion, which may be held invalid or unenforceable. P. Riverside Municipal Airport. Except for signs oriented so as to be primarily viewed from any public street other than Airport Drive, signs within Riverside Municipal Airport and which serve lessees of the Riverside Municipal Airport shall be governed by the Riverside Municipal Airport Sign Criteria adopted by resolution of the City Council and shall not be restricted by this chapter except for those provisions regarding maintenance and safety. Signs at the Municipal Airport are also subject to permits under the City Building Code. Q. Calculation of sign area. The area of an individual sign, as defined in Section 19.620.150 of this chapter, shall be calculated according to the following provisions. Sign area does not include supporting structures such as sign bases and columns provided that they contain no lettering or graphics except for addresses or required tags. The calculation of sign area for various types of signs is illustrated in Figures 19.620.070.Q-1, 2, and 3. 1. Single-faced signs. Where only one face of the sign includes written copy, logos, emblems, symbols, ornaments, illustrations, or other sign media, the sign area shall include the entire area within a single continuous perimeter composed of one or two rectangles that enclose the extreme limits of all sign elements on the face of the sign. Figure 19.620.070.Q-1: Measuring Area of Single-Faced Signs [image omitted; see the official code] 2. Double-faced signs. Where two faces of a double-faced sign have an interior angle of 45 degrees or less from one another, the sign area must be computed as the area of one face. Where the two faces are not equal in size, the larger sign face will be used. Where two faces of a double-faced sign have an interior angle of more than 45 degrees from one another, both sign faces will be counted toward sign area. Figure 19.620.070.Q-2: Measuring Area of Double-Faced Signs [image omitted; see the official code] 3. Multi-faced signs. Signs with three or more faces, where at least one interior angle is 45 degrees or more the calculation shall include the total area of each face that includes written copy, emblems, symbols, ornament, illustrations, or other sign media regardless of the dimension of each face. 4. Three dimensional signs. Signs that consist of one or more three-dimensional objects (i.e., balls, cubes, clusters of objects, sculpture, or statue-like trademarks), shall have a sign area that is the sum of the areas of the three visible vertical faces of the smallest cube or rectangular volume that will encompass the sign. Figure 19.620.070.Q-3: Measuring Area of Three-Dimensional Signs [image omitted; see the official code] R. Materials. Permanent signs may not be made of plywood, pressed board, non-exterior grade wood products or any material, such as paper or cardboard, that is subject to rapid deterioration and not weather-resistant. Materials used for temporary signs shall comply with applicable requirements of Section 19.620.090, Temporary Signs. Fabric signs shall be restricted to Public Service and Civic Identity Banners, Awning Signs, and Temporary Signs permitted pursuant to Section 19.620.090. S. Illumination. Unless specifically restricted by this chapter, signs may be illuminated or non-illuminated. The illumination of signs, from either an internal or external source, shall be designed to avoid negative impacts on surrounding rights-of-way and properties. The following standards shall apply to all illuminated signs: 1. Sign lighting shall not be of an intensity or brightness, or generate glare, that will create a nuisance for residential buildings in a direct line of sight to the sign; 2. External light sources shall be directed, shielded, and filtered to limit direct illumination of any object other than the sign; 3. Exposed incandescent lamps that exceed 40 watts or contain either internal or external metal reflectors are not permitted. 4. Refer to Section 19.620.080.C.5 for additional illumination requirements for electronic message center signs. T. Maintenance and safety. 1. Maintenance. All signs, together with all their supports, braces, guys and anchors, shall be kept in repair and in a proper state of preservation. The display surfaces of all signs shall be kept neatly painted or posted. The Community & Economic Development Director or his/her designee may order the removal of any sign that is not maintained in accordance with the provisions of this chapter and all other applicable laws. 2. Interference with safety passages. No sign or sign structure shall be erected in such a manner that any portion of its surface or supports will interfere in any way with the free use of any fire escape, exit or standpipe. No sign shall obstruct any window to such an extent that any light, ventilation or access is reduced to a point below that required by any law or ordinance. 3. Proximity to electrical facilities. No sign or structure shall be erected in such a manner that any portion of its surface or supports shall be within six feet of overhead electric conductors, which are energized in excess of 750 volts, nor within three feet of conductors energized at 0 to 750 volts. 4. Electrical signs. Electrical signs shall bear the label of an approved testing laboratory. Said label shall not exceed four square inches. Said label shall be placed as directed by the Community & Economic Development Director or his/her designee. Electrical signs and appurtenant equipment shall be installed in accordance with the Electrical Code. 5. Engineering design and materials. Signs designed and constructed as building elements or structures shall be in accordance with the provisions of the Building Code. 6. Inspections. It shall be the duty of every person who may erect any sign designated under this chapter to afford ample means and accommodation for the purpose of inspection whenever, in the judgment of the Community & Economic Development Director or his/her designee or the Building Official, such inspection is necessary. The inspectors for the Public Utilities Department and the Fire Department of the City shall also have the right and authority to inspect any such signs during reasonable hours. 7. Liability of owners. This chapter shall not be construed to relieve from or lessen the responsibility of any person owning, maintaining, operating, constructing or installing any sign or other device mentioned in this chapter for damages to life or property caused by any defect therein. 8. City responsibility for sign compliance. Neither the City nor any agent thereof may be held as assuming any liability by reason of the inspection required by this chapter. Nothing in this chapter waives or diminishes any defenses the City may have in any action alleging that the City is responsible, in whole or in part, for damage, loss or injury caused by any sign. By enacting this chapter the City does not waive its immunities under California statutory law, including but not limited to the governmental immunities.
(Ord. 7717, § 4(Exh. A), 2025; Ord. No. 7701, § 39, 2025; Ord. 7331 §96, 2016; Ord. 7300 §2, 2015; Ord. 6966 §1, 2007)
Ask a question about Riverside law
Corpus searches the Riverside sections it holds and shows the ones that match, with their citations. Free, no sign-in.
