Screening
Reno Annexation and Land Development Code § 18.04.808
in effect18.04.808 - Screening
(a) Conflicting Regulations In case of conflict between the screening standards in this section and any screening standards stated in a different chapter, article, or section of this Title, the most restrictive screening standard shall apply.
(b) Screening Between Land Uses
(1) Required Screening Screening shall be required with new development where the new use is different from the existing abutting use, as shown in Table 4-17, below.
Table 4-17 Minimum Required Use Screening
New Use | Abutting Use
Specific uses within these broader categories are identified in Table 3-1 Table of Allowed Uses | Single Family | Multi-family | Public, Institutional, and Civic Uses | Commercial | Industrial
Single Family | NA | Solid | Wall | Solid | Wall
Multi-family | Solid | NA | Semi-opaque | Solid | Wall
Public, Institutional, and Civic Uses | Wall | Semi-opaque | NA | Solid | Wall
Commercial | Solid | Solid | Solid | NA | Solid
Industrial | Wall | Wall | Wall | Solid | NA
Notes: [1] Refer to subsection 18.04.808(b)(2) Land Use Screening Types for defined screening methods [2] See Chapter 18.04 Article 14, Residential Adjacency, for additional standards. [3] Screening standards for Public and Quasi-Public Utilities and Service Uses are included in the appropriate Use-Specific Standards founds in Section 18.03.305.
a. Installation Required screening shall be installed by new development that is adjacent to previously developed property.
b. Substitution of Screening Where a semi-opaque screen is required, a solid screen may be installed.
c. Maintenance of Screening All screening between land uses installed according to this section shall be maintained for the life of the installing use in good repair and condition sufficient to remain effective for the intended screening purpose.
d. Alternative Screening Alternative screening may be approved through a minor site plan review, based on the nature and scale of the impacts of the proposed use including, but not limited to, noise, lighting, traffic, and drainage considerations. There are instances where open fencing such as tubular steel and wrought iron may be more appropriate for security and may be approved by the Administrator.
(2) Exemptions All MD-districts are exempt from the above screening requirements. Additionally, any vertical mixed-use project where multiple uses are proposed in one building are exempt from the above screening requirements.
(3) Land Use Screening Types The following types of screening shall be used to screen between land uses:
a. Solid A six-foot high solid masonry, metal, composite, or wood fence with five feet of landscaping adjacent to it with a minimum of one evergreen tree planted every 20 linear feet and a minimum six shrubs planted per tree. See Figure 4-10, below.
[image omitted; see the official code]
Figure 4-10: Solid Screening
b. Semi-Opaque
1. An eight-foot wide landscape area that consists of trees which achieve at least 20 feet in height at maturity and are planted at a rate of every 20 feet and a minimum six shrubs planted per tree, with a three-foot high masonry wall. See Figure 4-11, below.
[image omitted; see the official code]
Figure 4-11: Semi-Opaque
2. A 15-foot wide landscape area that consists of trees that achieve at least 20 feet in height at maturity and are planted at a rate of one for every 20 feet on top of a two-foot high berm interspersed with six shrubs per tree to achieve a screening effect.
3. A 30-foot wide landscape area that consists of trees planted at a rate of one for every 20 feet and a minimum six shrubs planted per tree.
c. Wall A six-foot high solid masonry wall with five feet of landscaping adjacent to it with a minimum of one evergreen tree planted every 20 linear feet and a minimum six shrubs planted per tree.
(c) Screening of Outdoor Service Areas, Utilities, and Equipment
(1) Trash Receptacles
a. Applicability To screen trash and recycling receptacles, enclosures shall be constructed with any commercial, office, public building, multi-family building with more than four units, or industrial development, unless otherwise exempted by this section. Additional features may be required by the solid waste provider or environmental control standards.
[image omitted; see the official code]
Figure 4-12: Trash and Recycling Receptacle Screening
b. Additional/Oversized Enclosures Developments generating ten or more yards of trash per receptacle within any pickup cycle shall expand the size of the enclosure to accommodate demand or shall construct an additional enclosure.
c. Location of Trash Receptacles
1. All Uses
[a] General Trash receptacles shall be located outside building setback lines and buffer yards, and to the side or rear of the principal building. Where the trash receptacle(s) are interior to the site and not visible from any public right-of-way or adjacent property, enclosure may be waived. Trash receptacles may be located on a property line that is adjacent to an alley.
[b] Adjacent to Residential Properties Trash receptacles shall be screened and odor-controlled. In addition, trash receptacles shall be located a minimum of 25 feet from any residential property line, or as far away from the residential property line as possible.
[c] The location of the trash receptacle may be modified from these standards, subject to the approval of the Administrator.
2. Residential Uses Trash storage may be located on a property line that is immediately adjacent to an alley.
3. Location on Plans Trash enclosure locations shall be indicated on the plans accompanying any application and the plans submitted for building permit approval.
4. Recycling Containers On-site recycling containers shall be provided for the construction or major renovation of an apartment complex or condominium pursuant to NRS Section 278.02315. On-site recycling containers shall be provided for the construction or major renovation of all non-residential development.
(2) Mechanical Equipment and Alternative Utility Systems
a. All mechanical equipment, including, but not limited to, air conditioners, electric meters, heating units, and alternative utility systems (except for wind turbines and solar panels), shall be screened from view of streets and residential areas. This shall apply to equipment and alternative utility systems located on rooftops, at ground level and at any other position upon the structure with the exception of single-family or duplex dwellings and window or wall mounted air conditioners in residential uses and the exceptions identified in Section 18.04.808(c)(2)d, below.
b. Screening shall be architecturally compatible with the structure, and window mounted air conditioners/heaters in residential buildings shall be considered screened if such equipment consists of a color and material which blends with the rest of the structure, and if the equipment does not extend greater than six inches beyond the plane of the building.
c. Backflow preventers shall be screened from view of public streets and adjoining properties by low vegetation, walls, covers, or fencing, or other means acceptable to the Administrator.
d. Every effort shall be made to adequately screen alternative utility systems according to the terms of this section or to integrate them into the design of the primary structure consistent with City design policies; unless it can be proven to the satisfaction of the Administrator that adherence would significantly decrease the efficiency or performance of the system.
(3) Loading Areas Loading areas shall be located at the side or rear of the building, and screened from view of public rights-of-way, single-family or duplex zoned lots, parks, and other public areas by a screen that is tall enough to screen vehicles and service areas.
(Ord. No. 6692, § 1(Exh. A), 1-8-25)
Source: City of Reno, Nevada, Administrative Code, City Charter and Annexation and Land Development Code (Municode Library, library.municode.com)URL: https://library.municode.com/nv/reno/codes/land_development_code?nodeId=CH18.04DEST_ART8LABUSCFE_18.04.808SCFetched: 11/1/2026
