Noise measurement procedures.
Round Rock Code of Ordinances § 14-211
in effectSec. 14-211. - Noise measurement procedures.
(a) Measurement with sound level meter.
(1) Whenever portions of this article prohibit sound over a certain decibel limit, measurement of the sound will be made with a Type 1 or Type 2 calibrated sound level meter utilizing the A-weighting scale and the slow meter response as specified by the American National Standards Institute (ANSI S1.4-1984/85A).
(2) Noise levels will be measured in decibels and A-weighted. The unit of measurement will be designated "dB(A)."
(3) Meters must be maintained in calibration and in good working order. Calibrations will be employed that meet ANSI S1.40-1984 prior to and immediately after every sampling of sound.
(4) Measurements recorded must be taken so as to provide a proper representation of the sound being measured.
(5) The microphone of the meter should be positioned so as not to create any unnatural enhancement or diminution of the measured sound. A windscreen for the microphone must be used.
(6) Except as otherwise provided, measurements will be taken at or near the nearest property line of the property where the sound is being received.
(b) Measurement without sound level meter. Any city official with enforcement authority under this article who hears a noise that is plainly audible will assess the noise according to the following standards:
(1) The primary means of detection are the official's normal hearing faculties, so long as the official's hearing is not enhanced by any mechanical device, such as a hearing aid.
(2) The official must have a direct line of sight and hearing to the real property of the source of the noise so the official can readily identify the offending source of the noise and the distance involved. If the official is unable to have a direct line of sight and hearing to the real property of the source of the noise, then the official must confirm the source of the noise by approaching the suspected real property source of the noise until the official can obtain a direct line of sight and hearing, and identify the same noise that was heard at the place of original assessment.
(3) The official need not determine the particular words or phrases being said or produced, or the name of the song or artist producing the noise. The detection of a rhythmic bass reverberating type of noise is sufficient to constitute a plainly audible noise.
(Ord. No. G-07-11-08-0E1, § I(6.203), 11-8-2007)
Source: City of Round Rock, Texas, Code of Ordinances (Municode Library, library.municode.com)URL: https://library.municode.com/tx/round_rock/codes/code_of_ordinances?nodeId=PTIICOOR_CH14EN_ARTVIIINO_S14-211NOMEPRFetched: 11/16/2026
