Saint Paul Legislative Code § 66.331 Density and dimensional standards table.
Sec. 66.331. - Density and dimensional standards table.
Table 66.331, traditional neighborhood district dimensional standards, sets forth density and dimensional standards that are specific to traditional neighborhood districts. These standards are in addition to the provisions of Chapter 63, Regulations of General Applicability. Where an existing building does not conform to the following requirements, the building may be expanded without fully meeting the requirements as long as the expansion does not increase the nonconformity.
Table 66.331. Traditional Neighborhood District Dimensional Standards
Building Type by Zoning District | Density | Lot Size Minimum (per unit) | Building Height (feet) | Yard Setbacks (feet)
Min.—Max.(a) | Area (sq. ft.)(a) | Width (feet) | Min. | Max. | Front Min.—Max. | Side Min. | Rear Min.
T1
1- & 2-family dwelling | 0.3-1.0 FAR (e) | 1000 | 25 | none | 35 (d) | 10-25 (h) | (j) | 15
All other | 0.3-1.0 FAR (e) | n/a | n/a | none | 35 (d) | 0-25 (h) | (j) | (j)
T2
1- & 2-family dwelling | 0.3-1.0 FAR (e) | 1000 | 25 | none | 35 (d) | 10-25 (h) | (j) | 15
1000 | 25
All other | 0.3-2.0 FAR with surface parking, 0.3-3.0 FAR with structured or no parking, and 0.5 min. FAR in light rail station areas (cb), (e) | n/a | n/a | none | 45 (d) | 0-10 (h), (i) | (j) | (j)
T3
All | 0.5-3.0 FAR (c), (e) | n/a | n/a | 25 | 55(d), (f) | 0-10 (h), (i) | (j) | (j)
T4
All | 0.5 min. FAR (c) | n/a | n/a | 25 | 75 (d), (g) | 0-10 (h), (i) | (j) | (j)
Min.—Minimum Max.—Maximum FAR—Floor Area Ratio n/a—not applicable
Notes to table 66.331, traditional neighborhood district dimensional standards:
(a) In calculating the area of a lot that adjoins a dedicated public alley, for the purpose of applying minimum lot area and maximum density requirements, one-half (½) the width of such alley adjoining the lot is considered part of the lot. The minimum FAR applies to new buildings. The minimum FAR does not apply to the creation or reconfiguration of lots, or to removal of buildings. For a new building on a zoning lot where an existing building will remain, or where the new building and its associated parking and landscaping will cover only part of the site and leave the rest of the site open for an additional building, minimum FAR may be calculated based on the area of the site covered by the new building and its associated parking and landscaping. Public gathering areas, landscaped areas at least twenty (20) feet wide preserved for future development between the public right-of-way and parking, and land dedicated to the city as public right-of-way may be approved by the planning administrator as counting toward meeting the minimum FAR.
(b) Floor area ratio (FAR) must be prorated upon the percentage of parking that is provided as structured parking. Thirty (30) percent of the floor area of structured parking within, above, or below the principal structure may be counted toward meeting the minimum FAR.
(c) 1.0-3.0 FAR in light rail station areas for lots more than twenty-five thousand (25,000) square feet in area, with no maximum FAR in T4. The floor area of structured parking above or below space used for principal uses, up to an amount equal to the floor area of the principal uses, may be counted toward meeting the minimum FAR. For lots more than twenty-five thousand (25,000) square feet partly in a light rail station area, minimum FAR must be prorated upon the percentage of the lot in a light rail station area.
(d) Height of structures may exceed the maximum if set back from side and rear setback lines a distance equal to additional height. Structures must be no more than thirty (30) feet high along side and rear property lines adjoining RL-H2 residential districts at a common property line or alley; structures may exceed this thirty (30) foot height limit if stepped back from side and rear property lines a distance equal to the additional height. Additional building height is permitted when stated in an adopted T District master plan.
(e) In T1 - T3, the FAR maximum may be increased by zero and five tenths (0.5) if at least ten (10) percent of new dwelling units are leased at a rate at or below the sixty (60) percent of the area median income (AMI) rent limits as defined by the Multifamily Tax Subsidy Program rent and income limits published by Minnesota Housing, and are affordable to households earning up to sixty (60) percent of the area median income for at least ten (10) years. The FAR maximum may be increased by an additional zero and five tenths (0.5) (total of one and zero tenths (1.0) increase) if at least twenty (20) percent of new dwelling units are leased at a rate at or below the sixty (60) percent of the area median income (AMI) rent limits as defined by the Multifamily Tax Subsidy Program rent and income limits published by Minnesota Housing, and are affordable to households earning up to sixty (60) percent of the area median income for at least ten (10) years. Each unit required to be affordable must be occupied by a household earning up to sixty (60) percent of the area median income. Prior to issuance of a building permit for the new building (or building expansion or conversion), demonstration of the commitment to affordable housing in accordance with this footnote must be provided as a deed restriction or other contractual agreement with the city, or a city housing and redevelopment authority financing agreement or other similar financing agreement. Upon occupancy of the units, documentation of the households' income qualifications is required.
(f) A maximum height of ninety (90) feet may be permitted with a conditional use permit. Structures must be stepped back one (1) foot from all setback lines for every two and one-half (2½) feet of height over seventy-five (75) feet. A shadow study may be required for a conditional use permit application to help determine the impact of the additional height. Additional building height is permitted when stated in an adopted T District master plan.
(g) Except in light rail station areas between Lexington Parkway and Marion Street, a maximum height of ninety (90) feet may be permitted with a conditional use permit. Structures shall be stepped back one (1) foot from all setback lines for every two and one-half (2½) feet of height over seventy-five (75) feet. A shadow study may be required for a conditional use permit application to help determine the impact of additional height.
(h) The minimum front yard setback must not exceed the maximum front yard setback requirement. If an interior lot is abutting BC or residential zoning, it may have setbacks up to twenty-five (25) feet to relate to the existing established building facade line. Up to forty (40) percent of the building facade on any lot may exceed the maximum setback to create outdoor seating, gathering areas, or courtyards. Civic and institutional buildings in T1 and T2 districts are exempt from the maximum front yard setback requirement. On corner lots at transitway platforms, no portion of a structure is allowed in the triangular area of the lot included within fifteen (15) feet of the corner along each lot line. For local heritage preservation sites, the minimum and maximum setback standards may be modified to comply with the preservation program and design review guidelines.
(i) For properties fronting on University Avenue between Marion and Emerald Streets a minimum four (4) foot front yard setback is required. The four (4) foot setback must be either landscaped or paved. If paved (preferred), the property owner may provide a permanent easement to the city to provide additional sidewalk space. An additional six (6) feet may be added to provide an outdoor activity zone, pedestrian seating or amenities, resulting in a building setback of ten (10) feet. For local heritage preservation sites, the standard may be modified to comply with the preservation program and design review guidelines.
(j) No side or rear yards are required along the interior lot lines except as otherwise specified in the building code; provided, that if walls of structures facing such interior lot lines contain windows or other openings, yards of not less than six (6) feet must be provided. Side and rear yards of at least six (6) feet are required when a nonresidential use adjoins a side yard of a residential property. These setback requirements from interior lot lines shall be waived when an easement agreement is recorded as to the affected properties. Proof of such recorded easement shall be provided at the time of application for a building permit. The recording of the easement agreement shall be interpreted to mean that the following intents and purposes of these setback requirements are met: adequate supply of light and air to adjacent property; sufficient space for maintenance of the building from the same lot; and prevention of damage to adjoining property by fire or runoff from roofs. The setback must be a minimum of thirteen (13) feet from the centerline of an adjoining alley.
(Ord. No. 11-27, § 1, 4-20-11; Ord 14-12, § 2, 6-4-14; Ord 15-5, § 3, 2-5-15; Ord 15-20, § 2, 6-10-15; Ord 21-27, § 1, 8-18-21; Ord 22-1, § 3, 1-19-22; Ord 25-34, § 7, 7-16-25; Ord. No. 25-59, § 4, 11-12-25; Ord. No. 25-72, § 1, 12-10-25)
