Omaha Municipal Code § 49-1000 Bar and soda waste.
Sec. 49-1000. - Bar and soda waste.
Waste from beer taps, soda beverages, liquor, wine, bar sinks and coffee will be considered corrosive waste and the waste piping shall be installed as follows:
(a) Materials allowed:
(1) Polyethylene and polypropylene plastic pipe and fittings with socket style, heat-fusion joints. All joints shall be made in accordance with ASTM Standards D2657 and D3309.
(2) Schedule 40 or heavier polyvinyl chloride (PVC) pipe and fitting may be used underground for such waste and may be extended no more than one inch above the floor.
(3) Schedule 40 chlorinated polyvinyl chloride (CPVC) waste pipe and fitting.
(4) All floor drains, floor sinks and trench drains shall be of a type approved elsewhere in this chapter.
(b) The vents for any fixture receiving corrosive waste shall be constructed of materials approved in this chapter.
(c) Shall run independent of all other waste and connect to another waste or soil line where sufficient water will dilute and flush the corrosive waste.
(d) No waste from beer taps, soda beverages, liquor, wine, bar sinks, coffee and tea shall connect to a waste line that terminates at a grease interceptor or grease removal device.
(e) Only long sweep fittings shall be installed.
(f) Threaded plastic fittings shall not be used underground.
(g) Whenever the pipe passes through a slab-on-grade concrete floor, it shall have a minimum one-half inch thick wrap to allow for adequate free movement due to thermal expansion.
(h) Only approved transition fittings shall be permitted.
(i) Hangers and straps shall be as noted elsewhere in article VIII of this chapter.
(j) Hangers using threaded rod and adjustable swivel ring or clevis type hangers shall be double-nutted.
(k) If the waste is extended through a fire rated floor or partition, other accepted fire stopping materials, techniques and devices may be required.
(l) Floor drains made of plastic shall not be allowed.
(m) Maximum length and capacities of the waste line shall conform to sections 49-903 and 49-906.
(Ord. No. 40524, § 1, 10-20-15)
