§ 49-29 — BACKFLOW PREVENTION DEVICES
Dallas City Code (7/2026 Code (S-33): Vols. I-II current through Ordinance 33447, passed June 10, 2026; Vol. III through Ordinance 33484, passed June 24, 2026) · Dallas City Code § 49-29
Corpus is an independent public-information project, not the official City of Dallas website. Stable reference: corpuslaw.us/code/ce567afc-c7b3-4c49-bd9d-b03694834b15
SEC. 49-29. BACKFLOW PREVENTION DEVICES.
(a) Authority to require. The director may enforce this section in accordance with the Dallas Plumbing Code, this article, and other applicable regulations promulgated by the Texas Commission on Environmental Quality (TCEQ); Section 290.44 of the Texas Administrative Code; and cross-connection control requirements including: (1) giving notice and requiring a customer to install an approved backflow prevention device at the customer’s own expense, where the director determines that the device is necessary for protection of the potable water system or private premise plumbing; (2) giving notice and requiring a customer to correct a defective backflow prevention device at the customer’s own expense. Failure to comply may result in refusal of service and referral to municipal court. Each day that a customer fails to comply with a notice under this paragraph constitutes a separate violation; (3) refusing or discontinuing service if a backflow prevention device is not installed, tested, or corrected as provided in this section; and (4) inspecting backflow prevention devices and charging fees for the inspection in accordance with Section 49-18.6(d). (b) Maintenance responsibility. The customer is responsible for general maintenance and upkeep of an approved backflow prevention device in accordance with the Dallas Plumbing Code, this article, and other applicable regulations promulgated by the Texas Commission on Environmental Quality (TCEQ); and Section 290.44 of the Texas Administrative Code. (1) All backflow prevention assembly tests must be conducted by a city registered and TCEQ- licensed backflow prevention assembly tester (BPAT). (2) All backflow prevention assemblies must be tested upon installation and certified to be operating within specifications. (3) Backflow prevention assemblies that are installed to protect against health hazards must also be tested and certified at least annually to be operating within specifications. (4) All backflow prevention assembly test and maintenance reports must be submitted to director. (c) Damage from inspection. The city and the director are not responsible for damage done during inspection that is a result of corrosion or improper maintenance of a backflow prevention device. (Ord. Nos. 19201; 33420 )
Ask a question about Dallas law
Corpus searches the Dallas sections it holds and shows the ones that match, with their citations. Free, no sign-in.
