Subdivision walls.
Round Rock Zoning and Development Code, art. II, § 4-30
in effectSec. 4-30. - Subdivision walls.
(a) Walls required. Where subdivisions are platted so that the rear and/or side yards of residential lots are adjacent to a major collector or higher classification street, the developer shall construct, at his sole expense, walls between said rear and/or side yards and said street, in accordance with the standards set forth below. Where said lots are corner lots, the wall requirements of this section shall take precedence over corner lot fencing specifications regulated by Sec. 8-35.
(b) Standards. It is intended that all walls erected pursuant to this section be constructed in such a manner to last 30 years with minimal maintenance required during said period. All walls required by this section shall conform to the following minimum standards:
(1) Where applicable, materials and installation of walls shall comply with the most recent edition of "Selected ASTM Standards for Fence Materials and Products," a copy of which shall be maintained by the PDS director. Structural plans and specifications for walls shall be approved by the PDS director. Such plans and specifications are to be submitted at the same time as other construction plans required by this chapter. In approving said plans and specifications, the PDS director shall consider the site's soil characteristics, wind loadings and other environmental considerations.
(2) Walls shall be constructed of the following materials: brick, natural stone, simulated stone, split-faced or architectural concrete masonry unit (CMU), decorative reinforced concrete, or other equivalent materials approved by the PDS director.
(3) Walls shall be a minimum of six (6) feet and a maximum of eight (8) feet in height. The materials, color and design of walls shall be uniform within an approved preliminary plat, unless otherwise approved by the planning department. A finished side of all walls shall face the thoroughfare.
(4) All walls shall be placed at least five (5) feet from any existing or proposed city water line, reuse water line or wastewater line.
(5) All walls required herein shall be placed along the property line between the right-of-way and the adjoining private property and outside any easements.
(c) Miscellaneous provisions.
(1) A plat note describing the location of proposed wall and associated landscaping including irrigation shall be included on the preliminary plat and final plat.
(2) Detail plans for walls and associated landscaping including irrigation shall be submitted with the construction plans for public improvements.
(3) Walls shall conform to the requirements of this Code governing sight distance for traffic safety.
(4) Prior to the city's acceptance of the public improvements the developer must complete all walls required herein.
(5) It is not the intent of this section to regulate the design and/or construction of entrances to subdivisions.
(6) The city, at its option, may maintain the wall. As a result, a five-foot (5') access easement shall be provided along the back and sides of the property abutting the wall for maintenance purposes.
Source: City of Round Rock, Texas, Code of Ordinances (Municode Library, library.municode.com)URL: https://library.municode.com/tx/round_rock/codes/code_of_ordinances?nodeId=PTIIIZODECO_CH4SUDECO_ARTIISUDEGERE_S4-30SUWAFetched: 11/16/2026
