Calculation of Density
Reno Annexation and Land Development Code § 18.04.405
in effect18.04.405 - Calculation of Density
To retain the natural features of hillsides, the maximum number of dwelling units shall be reduced as slope increases in accordance with Table 4-4, Hillside Density Calculation, and the following standards:
(a) General
(1) Each property to be developed shall be divided into cells of similar slope, utilizing the slope ranges listed in Table 4-4, Hillside Density Calculation.
(2) The 100-year floodplain of major drainageways plus a 15-foot-wide buffer on both sides shall be excluded from density calculations and shall not be allocated any development for purposes of hillside density calculations. (See Section 18.04.104 for applicable major drainageway standards.) Notwithstanding the above, the area excluded from density calculations shall not exceed 80 feet in width along each major drainageway.
(3) In zoning districts without residential base density standards, allowable development density shall be based on other applicable provisions of this Title.
(4) The maximum number of dwelling units allowed by Table 4-4, Hillside Density Calculation, may only be realized if the proposed development complies with all other applicable provisions of this article.
Table 4-4 Hillside Density Calculation
Slope Range | A: Density Reduction Factor [1] | B: Base Zoning Density (units/acre) [2,3] | C: Acres within Slope Range [3] | D: Dwelling Unit Allocation [3,4,5,6, 7]
0 - 15% | 1.0
15.1 - 20% | 0.6
20.1 - 25% | 0.2
25.1 - 30% | 0.1
Greater than 30% | No density allocation
Sum of This Column = Max. Dwelling Units for the Project
Notes: [1] Allowable dwelling units are determined at the project level - the dwelling unit allocation for each slope range is for calculations purposes only. [2] Base zoning density is identified in Chapter 18.02 Zoning Districts [3] Base zoning density, acres within each slope range, and the unit allocation for each slope range shall be rounded to two decimal points. [4] For each row, columns A, B, and C are multiplied to determine the number of dwelling units allocated to each slope range (column D). [5] The sum of allowable units within each slope range represents the maximum number of dwelling units for each project. [6] Maximum dwelling units for the project shall be rounded down to the next whole number. [7]Density bonus allocation in Article 15 can be applied to increase density beyond the hillside density calculation.
(Ord. No. 6692, § 1(Exh. A), 1-8-25)
Source: City of Reno, Nevada, Administrative Code, City Charter and Annexation and Land Development Code (Municode Library, library.municode.com)URL: https://library.municode.com/nv/reno/codes/land_development_code?nodeId=CH18.04DEST_ART4HIDE_18.04.405CADEFetched: 11/1/2026
