For AI agents: read the machine-readable documentation index at /llms.txt or the single-file full reference at /llms-full.txt.

§ 65.3 — Zones of the slope development district

Code of Ordinances of the City of Huntsville, Alabama (Supp. No. 30 (codified through Ord. No. 26-196, adopted March 12, 2026) with enacted ordinances through Ord. No. 26-837 (September 24, 2026) applied from official council minutes and ordinance copies) · Huntsville Code of Ordinances, App. A, art. 65, § 65.3

Corpus is an independent public-information project, not the official City of Huntsville website. Stable reference: corpuslaw.us/code/ddc20581-6ff7-4501-86bf-950491e4e095

65.3. - Zones of the slope development district.

The slope development district is hereby divided into two slope zones based on the increasing risk of instability and the decreasing safety factor associated with increasing slope as established by the Slope Development Study, Huntsville, Alabama, prepared by Ground Engineering and Testing Service, Inc., 1989. The zones are defined as follows: 65.3.1. Lower slope zone. This zone shall include all areas of land within the boundaries of the slope development district that are not part of the upper slope zone. 65.3.2. Upper slope zone. This zone shall include all areas of land within the boundaries of the slope development district beginning at the elevation contour defining the start of the 20 percent slope and encompassing all contiguous slopes of 20 percent or greater. The upper slope zone boundary shall be computed according to the procedure described in section 65.1.3 herein, where a 25-foot vertical span of mountainside has a slope of 20 percent or greater. The upper slope zone may begin at the lower district boundary, may extend to the upper district boundary if present, or may create one or more enclosed areas delineated by a continuous extension of the upper slope zone boundary. 65.3.3. If a lot is cut by the boundary contour separating the lower and upper slope zones, then the lot shall be considered to be a part of that slope zone in which the majority of its area is located. 65.3.4. Hazard zone. This zone shall include all areas of land within the boundaries of the Slope Development District that exhibit any or all of the following geologic or man-made hazards: (1) Pennington, shaley Upper Bangor, or Pride Mountain geologic formations; (2) Colluvial deposits having a depth of five feet or greater or being contiguous to an off-site colluvial deposit that exceeds five feet in depth; and (3) Evidence of mining operations (mine or quarry tailings, or similar geologic conditions). 65.3.5. For colluvial deposits present on a site to be removed from the hazard zone provisions, the following certification must be made a part of the site assessment map: I, ___________, the geotechnical engineer of record, having caused investigations to be performed and based on the findings of said investigations, do hereby certify that the colluvial deposits identified by location and extent on this map are less than five feet in depth and are not contiguous to any off-site colluvial deposit that exceeds five feet in depth. ________ | ________ Date | Geotechnical Engineer of Record 65.3.6. No buildings, structures or improvements shall be constructed, erected or placed on any land having a hazard zone designation, except where: (1) Such site has undergone additional geotechnical analysis and testing both upslope to where a potential landslide would begin and downslope to where a potential landslide would end, and (2) The engineer of record places the following signed certification on the final subdivision plat or, in the case of a multifamily development, on the site plan: I, ___________ the engineer of record, certify that the proposed development shown hereon is designed in accordance with sound engineering standards and practices, and in accordance with all applicable development regulations. I further certify that I have caused prudent investigation, testing and inspections to be performed on all lands within the proposed development identified as hazard zone, as defined by the zoning ordinance of the City of Huntsville, Alabama, including geotechnical analysis and testing on all hazard zone lands and on lands upslope and downslope of the proposed development, and I have instructed the land surveyor as to those areas within the proposed development that fall within the hazard zone for inclusion in the development plats. Based upon the investigation, testing and inspections performed, as defined and discussed in the geotechnical analysis and report dated ________ and submitted in connection herewith, and further based upon any remedial measures taken in connection with the hazards defined therein, I certify that, within acceptable geotechnical standards, development of the property as shown on the plat will not diminish the stability of the slope or otherwise increase the likelihood of landslide or other slope failure and that the buildable areas designated hereon can meet a minimum safety factor of 1.5 for stability. ________ | ________ Date | Engineer of Record (3) The owner of the property places the following signed certification on the final subdivision plat or, in the case of a multifamily development, on the site plan: I, ___________, owner/owners of the lands embraced hereon, hereby certify that I have caused investigation in accordance with sound engineering standards and practice to be made of hazard zone lands, as defined by the zoning ordinance of the City of Huntsville, Alabama, within the development as shown hereon. I further understand the potential and inherent danger of said lands and that landslides have originated in conditions that regularly exist on said hazard zone lands. With this knowledge, I hereby certify that I have caused all prudent measures to be taken in the design of the development as shown hereon, including an analysis of all lands upslope and downslope of the hazard zone lands, to assure that the site is safe for the proposed development, and within acceptable geotechnical standards the proposed development will not diminish the stability of the slope or otherwise increase the likelihood of landslide or other slope failure. ________ | ________ Date | Owner 65.3.7. Where a subdivision or multifamily site contains unbuildable hazard zone land, then such land may be included in lots if: (1) The specific hazard zone condition is identified and its extent is designated on the final plat or site plan; (2) The area of the hazard zone land is restricted to remain undisturbed and be retained in its natural state; (3) The area of the hazard zone land is so located that the lot or site can be developed without disruption to it; and (4) A restricted use buffer extends a minimum of 25 feet beyond the edge of the hazard zone land.

(Ord. No. 96-159, 4-25-1996)

Ask a question about Huntsville law

Corpus searches the Huntsville sections it holds and shows the ones that match, with their citations. Free, no sign-in.