For AI agents: read the machine-readable documentation index at /llms.txt or the single-file full reference at /llms-full.txt.

§ 65.5 — Development standards

Code of Ordinances of the City of Huntsville, Alabama (Supp. No. 30 (codified through Ord. No. 26-196, adopted March 12, 2026) with enacted ordinances through Ord. No. 26-837 (September 24, 2026) applied from official council minutes and ordinance copies) · Huntsville Code of Ordinances, App. A, art. 65, § 65.5

Corpus is an independent public-information project, not the official City of Huntsville website. Stable reference: corpuslaw.us/code/f5f8c598-ec9b-4f2d-8da3-99db46e8cff4

65.5. - Development standards.

65.5.1. Grading. (1) Natural slopes in excess of 35 percent shall not be graded except as needed to provide for utility service to developable areas of less than 35 percent slope and/or other officially adopted public facilities except that in no case shall any building or structure be allowed. (2) Grading on natural slopes of 25 percent or greater shall only be permitted for the construction and installation of roads, utilities, and other limited foundation grading, which can be shown to be sensitive to the existing terrain. Proposed structures on slopes of 25 percent to 35 percent shall be designed to conform to the terrain and shall utilize pier and beam, step, or other such foundations that require only limited excavation and filling. Areas of cut visible from any public right-of-way shall be screened by landscaping except in those cases where visible cuts in stable rock are impractical to screen. (3) No cut and no fill shall be allowed on any lot except for: (a) The construction of a primary use structure when the cut or fill is required for the construction of the building foundation, in which case the total area of such cut or fill, as measured from the exterior faces of the walls of the structure to the outer limits of the cut or fill, must be subtracted from the allotted amount of landscaped yard area as defined in section 65.5.3; (b) The construction of a driveway or parking area to access the primary use structure, in which case the total area of such cut or fill, as measured from the outer edges of the driveway or parking area to the outer limits of the cut or fill, must be subtracted from the allotted amount of landscaped yard area as defined in section 65.5.3; (c) The construction of utilities, provided all said areas of cut are restored to natural grade and revegetated to conform to the character of the surrounding natural terrain. In order to reduce grading disturbance during utility installation, all utilities shall be incorporated in common trenches, where practical, utilizing duct banks designed and constructed to current standards of Huntsville Utilities as the same may from time to time be amended; or (d) The testing of land, as required by the regulations of the City of Huntsville, or other bona fide geotechnical or geological testing provided that a testing plan consistent with the provisions of the subdivision regulations of the City of Huntsville is submitted to and approved by the zoning administrator prior to any cut or fill operation. (4) Mass grading of hilltops, ridges, and ravines shall be prohibited. (5) All slopes to be stabilized shall conform to the surrounding natural terrain and shall be revegetated so as to conform to the natural character of the surrounding area. 65.5.2. Environmental features. (1) Road alignment shall follow natural terrain wherever possible and no unnecessary cuts or fills shall be allowed for the sole purpose of creating additional lots or building sites. (2) A restricted use area shall extend a minimum of 50 feet from the following features: (a) Landslides. Setback measured from mapped boundary of landslide. (b) Perennial streams and major drainageways including, but not limited to, all streams and drainageways delineated by the U.S. Geological Survey and Tennessee Valley Authority on the 7.5 minute quadrangle topographic map series. Drainageways that have been modified by man or by natural processes so that they are different from those delineated on the 7.5 minute quadrangle maps shall be set back from as defined herein. In addition, some man-made drainageways as designated by the city engineer shall be set back from as defined herein. The 50-foot setbacks shall extend landward from the banks or normal high water points of the drainageways. (c) Bluffs of greater than 20 feet of relief. Setbacks shall extend from a line defining the top and bottom of said bluff. (3) A restricted use area shall extend a minimum of 25 feet from the following features: (a) Cave entrances. Setback measured from edge of cave entrance. (b) Sinkholes. Setback measured from edge of those sinkholes that exhibit three feet or greater depth of closed depression. (c) Perennial springs. Setback measured from perimeter of spring. (d) Abandoned quarries. Setbacks shall extend from the top and bottom of quarry face. (e) Historical and archeological sites. Setbacks shall extend from the boundaries of significant historical or archeological sites as determined by the Alabama Historical Commission. (f) Wetlands. Setbacks shall extend from the boundary of the wetland. (4) Areas within the above minimum setbacks shall be retained in their existing state and be restricted from all development except for hiking trails, provided such trails neither create nor increase a public hazard, and except for certain minimal grading within said setback, provided the following conditions are met: (a) Minimal grading is required to construct public utility service and/or roadways to adjacent properties; and (b) No technically feasible alternative route or construction method exists. (5) The site shall be suitable for development in the manner proposed, without hazards to persons or property on or off the tract, from probability of flooding, erosions, subsidence or slipping of the soil, or other geologic dangers. Condition of soil, ground water level, drainage, and topography shall be appropriate to both kind and pattern of such intended development. (6) The natural terrain shall not be disturbed, cut, filled, graded or rearranged by either the developer or subsequent property owners beyond that necessary for the construction of buildings and infrastructure to the extent herein permitted. 65.5.3. Landscaping. It is desirable that yards be maintained in a condition close to their natural state in order to reduce the potential negative impacts of stormwater runoff, erosion and sedimentation, chemical fertilizer pollution, and irrigation that are commonly associated with the establishment of lawns and other plantings not native to the mountain slopes; however, a landscaped yard may be created provided the following conditions are met: (1) In the lower slope zone, 70 percent of the lot shall be retained in its natural state. (2) In the upper slope zone, 80 percent of the lot shall be retained in its natural state unless the lot lies on a slope of 25 percent or greater, in which case the entire lot beyond the allotment for impervious cover shall be retained in its natural state. (3) Land lying within utility and drainage easements that is disrupted by installation or maintenance of public improvements shall not be counted as disturbed lot area for the purpose of section 65.5.3. (4) Natural state shall mean the original condition of the land prior to any development or other human disturbance. No grading, excavating, or filling and no construction of roads, driveways, parking areas or structures shall be allowed. No tree cutting shall be allowed except for sick or damaged trees or trees that create a health or safety hazard. Unpaved hiking trails may be permitted as may additional plantings of native trees, shrubs and wildflowers that would be compatible with and enhance the natural environment. (5) The allotted area of landscaped yard must be decreased by the amount of any areas of cut or fill utilized in construction of the primary use structure and/or driveway/parking areas that have not been finished with impervious cover or returned to their natural state through revegetation that conforms to the character of the surrounding natural terrain. (6) The majority of the landscaped area should be located on that portion of the lot which is upslope from the primary use structure in order to minimize the harmful effects of increased pollution, runoff and erosion on downslope properties. (7) Fill material that is imported to provide a base for landscape plantings shall be limited to the minimum amount necessary and no colluvial soil shall be used for fill. (8) Turf grass and other imported ground covers shall not be planted on colluvial soil. (9) Trees may be removed: (a) Within rights-of-way to allow road construction; (b) Along easements if necessary for construction of said utility; (c) As necessary to conduct geotechnical testing after approval of the testing plan by the zoning administrator. (d) Within the areas of cut or fill required for construction of primary use structures, driveways and parking areas; (e) On that portion of a lot not required to be maintained in its natural state; and (f) To eliminate sick or damaged trees or trees that create a health or safety hazard. (10) Tree topping and clear cutting are prohibited within the slope development district.

(Ord. No. 96-159, 4-25-1996; Ord. No. 07-460, § 5, 6-28-2007)

Ask a question about Huntsville law

Corpus searches the Huntsville sections it holds and shows the ones that match, with their citations. Free, no sign-in.