§ 131.0642

The minimum street frontage is 60 feet for any lot in the IP zones that fronts principally on a turnaround or on a curving street with a centerline radius of less than 100 feet. 131.0643 Setback Requirements in Industrial Zones (a) Front Setback in the IP, IL, IH, and IBT Zones. Up to 50 percent of the length of the building facade may observe the minimum front setback provided the remaining percentage observes the standard front setback. This may occur on a floor-by-floor basis. See Diagram 131-06A. 24 Chapter 13: Zones (2-2025) Diagram 131-06A Front Setback in the IP, IL, and IH Zones Front y ard Length of building fac ade Min front s etback Standard front s etback CL STREET Building Up to 50% of the length of the building fac ade may obs erv e the minimum front s etback (b) Parking Encroachment in Front Yard of All Industrial Zones. Parking may encroach up to 5 feet into the required standard front yard in all industrial zones, but may not be covered or enclosed. (c) Parking Encroachment in Street Side Yard of IP, IL, IH, and IBT Zones. Parking may encroach up to 5 feet into the required standard street side yard of the IP, IL, and IH zones, but may not be covered or enclosed. (d) Rear Setback in IL Zones. In the IL zones, no rear setback is required for up to 50 percent of the width of the building envelope provided the remainder of the building envelope observes at least the standard rear setback as shown in Diagram 131-06B. 25 Chapter 13: Zones (2-2025) Diagram 131-06B Zero Rear Setback in the IL Zone CL STREET Building Side setback No rear setback is required for up to 50% of the width of the building envelope Width of building envelope Rear yard Standard rear setback Side setback (e) Standard/Minimum Street Side Setback in the IL, IH, and IBT Zones. Up to 50 percent of the length of the street side building facade may observe the minimum street side setback provided the remaining percentage observes the standard street side setback. This may occur on a floor-by-floor basis. (f) Side Setbacks in the IS Zone. In the IS zone, no side setback is required on one side of the lot. A minimum 5-foot setback is required for the opposite side. (g) Street Side Setbacks in the IS Zone. In the IS zone, the minimum street side setback is 10 feet for a premises that is 100 feet wide or greater. For a premises that is less than 100 feet, the minimum is 10 percent of the premises width but not less than 5 feet. 26 Chapter 13: Zones (2-2025)