§ 44-174 — Definitions
Code of Ordinances, City of Round Rock, Texas (Supp. 27: codified through Ordinance of August 13, 2026 (online updated November 5, 2026)) · Round Rock Code of Ordinances § 44-174
Corpus is an independent public-information project, not the official City of Round Rock website. Stable reference URL
Sec. 44-174. - Definitions.
For the purpose of this article, the following definitions shall apply unless the context clearly indicates or requires a different meaning. If a word used in this article is not contained in the following list, it shall have the definition listed in section 44-5 or in the most recent edition of the Manual of Cross Connection Control published by the Foundation for Cross-Connection Control and Hydraulic Research, University of Southern California. The following definitions shall apply to this article: Air gap means a physical separation between the free flowing discharge end of a potable water supply piping and/or appurtenance and an open or non-pressure receiving vessel, plumbing fixture or other device. An "approved air-gap separation" shall be at least twice the diameter of the supply pipe measured vertically above the overflow rim of the vessel, plumbing fixture or other device, and shall not be less than one inch in any case. Approved backflow prevention assembly or backflow assembly or assembly means an assembly to counteract back pressure or prevent backsiphonage. Atmospheric vacuum breaker backflow prevention device or atmospheric vacuum breaker or AVB means a device used to prevent backsiphonage in non-health hazard conditions. This device cannot be tested and cannot prevent backpressure backflow. Auxiliary supply means any water source or system other than the public potable water system that is or may be available in a building or on real property, including reuse water, groundwater or surface water used for industrial, irrigation or any other purpose. Backflow means the flow in the direction opposite to the normal flow of the city's potable water system, or the introduction of any foreign liquids, gases, or substances into the city's potable water system. Backflow prevention assembly tester means a licensed tester who is registered with the city's third party vendor to test backflow pressure assemblies on any domestic, commercial, industrial or irrigation service. Backpressure means any elevation of pressure in the downstream piping system (by any means) above the supply pressure at the point of consideration which would cause, or tend to cause, a reversal of the normal direction of flow of water in the city's potable water system, or the introduction of fluids, mixtures or substances from any source other than the intended source. Backsiphonage means the flow of water or other liquids, mixture or substances into the distribution pipes of a potable water supply system from any source, other than its intended source, caused by a sudden reduction of pressure in the potable water supply system. Boresight or boresight to daylight means the provision of adequate drainage for assemblies installed in vaults through the use of an unobstructed drain pipe. Commercial establishment means any property or location which is used for the manufacture, production, storage, wholesaling or retailing of any good or ware which is, or may be, placed in the flow of commerce, or any property or location which is used for the provision of any service for compensation. Contaminants means any foreign material, solid or liquid, not common to the potable water supply which makes or may make the water unfit or undesirable for human or animal consumption. Contamination means the admission of contaminants into the potable water supply system. Cross connection means any connection, physical or otherwise, between a potable water supply system and any plumbing fixture or any tank, receptacle, equipment or device through which it may be possible for any reuse, nonpotable, used, unclean, polluted and/or contaminated water, or other substances, to enter into any part of such potable water system under any condition or set of conditions. Cross connection control device means any device placed upon any connection, physical or otherwise, between a potable water supply system and any plumbing fixture or any tank, receptacle, equipment or device, which is designed to prevent reuse, nonpotable, used, unclean, polluted and/or contaminated water, or other substances, from entering into any part of such potable water system under any condition or set of conditions. Degree of hazard means the hazard classification that shall be assigned to all actual or potential cross connections. (1) The term "health hazard" means an actual or potential threat of contamination of a physical or toxic nature to the public potable water system or the consumer's potable water system that would be a danger to health. (2) The term "high hazard" means the classification assigned to an actual or potential cross connection that potentially could allow a substance that may cause illness or death to backflow into the potable water supply. (3) The term "low hazard" means the classification assigned to an actual or potential cross connection that potentially could allow a substance that may be objectionable but not hazardous to a person's health to backflow into the potable water supply. (4) The term "plumbing hazard" means an internal or plumbing-type cross connection in a consumer's potable water system that may be either a pollutional or a contamination-type hazard. (5) The term "pollutional hazard" means an actual or potential threat to the physical properties of the water system or the potability of the public or the consumer's potable water system but which would not constitute a health or system hazard, as defined herein. Maximum degree of intensity of pollution which the potable water system could be degraded under this definition would cause a nuisance or be aesthetically objectionable or could cause damage to the system or its appurtenances. (6) The term "system hazard" means an actual or potential threat of severe danger to the physical properties of the public or consumer's potable water supply or of pollution or contamination that would have a detrimental effect on the quality of the potable water in the system. Director means director of public works, or his designee. Double check detector backflow prevention assembly or double check detector or DCDA means an assembly composed of a line-size approved double check assembly with a bypass containing a specific water meter and an approved double check valve assembly. The meter shall register accurately for very low rates of flow. Double check valve backflow prevention assembly or double check assembly or double check or DC means an assembly which consists of two independently acting, approved check valves, including tightly closing resilient seated shutoff valves attached at each end of the assembly and fitted with properly located resilient seated test cocks. Fireline tester means a tester who is employed by a state-approved fireline contractor and is qualified to test assemblies on firelines only. Mobile unit means any operation which may have the potential to introduce contaminants into a potable water system from a mobile source. These include, but are not limited to, carpet-cleaning vehicles, water-hauling vehicles, street-cleaning vehicles, liquid-waste vehicles, power-wash operations and pest-control vehicles. Non-residential use means water used by any person other than a residential customer of the water supply and include all uses not specifically included in "residential uses." Point-of-use isolation means the appropriate backflow prevention within the consumer's water system at the point at which the actual or potential cross connection exists. Potable water supply means any water supply intended or used for human consumption or other domestic use. Premises means any piece of property to which water is provided, including all improvements, mobile structures, and structures located on the property. Premises isolation means the appropriate backflow prevention at the service connection between the public water system and the water user. Pressure vacuum breaker backflow prevention assembly or pressure vacuum breaker or PVB means an assembly which provides protection against backsiphonage, but does not provide adequate protection against backpressure backflow. The assembly is a combination of a single check valve with an AVB and can be used with downstream resilient seated shutoff valves. In addition, the assembly must have suction and discharge gate valves and resilient seated test cocks which allow the complete testing of the assembly. Public water system or water system means any public or privately owned water system which supplies water for public domestic use. The system will include all services, reservoirs, facilities, and any equipment used in the process of producing, treating, storing, or conveying water for public consumption. Reduced pressure principal detector backflow prevention assembly or reduced pressure detector orRPDA means an assembly composed of a line-size approved reduced pressure principle assembly with a bypass containing a specific water meter and an approved reduced pressure principle backflow prevention assembly. The meter must be capable of accurately registering very low rates of flow. Reduced pressure principle backflow prevention assembly or reduced pressure principle assembly or RP assembly or RP means an assembly containing two independently acting approved check valves together with a hydraulically-operated, mechanically independent pressure differential relief valve located between the check valves and below the first check valve. The assembly shall include properly located resilient seated test cocks and a tightly closing resilient seated shutoff valve the end of the assembly. Residential use means water use of any residential customer of the water supply and shall include, but is not limited to, single-family dwellings, duplexes, multiplex, housing and apartments where the individual units are each on a separate meter; or, in cases where two or more units are served by one meter, the units are full-time dwellings. Service connection means the point of delivery at which the water supplier loses control of the water. Spill-resistant pressure vacuum breaker or SVB means an assembly containing an independently operating, internally loaded check valve and an independently operating, loaded air inlet valve located on the discharge side of the check valve. This assembly must be equipped with a properly located resilient seated test cock and tightly closing resilient seated shutoff valves attached at each end of the assembly. Tamper means to interfere in a harmful or disruptive manner, or to make alterations or adjustments. Thermal expansion means heated water that does not have the space to expand. Third party vendor means a third party contracted by the city to provide backflow testing notification and data management services on behalf of the city. Used water means water supplied by a public water system to a water user's system after it has passed through the service connection. Water customer is the person or company on the water billing account agreement with the city.
(Code 1995, § 10.702; Ord. No. O-2014-1645, § XIV, 8-28-2014; Ord. No. O-2015-2423, § I, 5-14-2015; Ord. No. O-2016-3846, § I, 10-27-2016; Ord. No. O-2024-266, § XVI, 9-26-2024)
