General standards.
Tulsa Revised Ordinances tit. 42, § 67.030
in effectSection 67.030. - General standards.
All outdoor lighting must comply with the following general standards:
A. Canopy-mounted lights. Recessed fixtures must be used in all under-canopy lighting. No lamps, reflectors, refractors or focusing or diffusing may extend below the underside of the canopy surface.
B. Arrangement and shielding.
1. Lighting must be installed to shield and direct light away from abutting lots that are not under common ownership or control with the lot on which the lights are located. Shielding must be designed and installed to ensure that the light-producing element of the fixture is not visible from on the abutting property, as measured five (5) feet above grade.
2. Light-producing elements must be concealed or shielded with cutoffs so that no more than two and one-half (2.5) percent of the light emitted directly from the lamp or indirectly from the fixture is projected at an angle of more than ninety (90) degrees above nadir and no more than ten (10) percent of the light emitted directly from the lamp or indirectly from the fixture is projected at an angle of more than eighty (80) degrees above nadir.
Figure 67-1: Required Shielding
[image omitted; see the official code]
C. Spillover light. Light trespass along the lot line of the subject property may not exceed 0.5 foot-candles when abutting an agricultural, agricultural-residential or residential zoning district and may not exceed 3.0 foot-candles when abutting any other zoning district or public right-of-way. Maximum illumination levels are measured three (3) feet above grade or from the top of any opaque screening fence or wall along the property line.
(Ord. No. 24382, § 15, 6-10-2020)
Source: City of Tulsa, Revised Ordinances and City Charter (Municode Library, library.municode.com)URL: https://library.municode.com/ok/tulsa/codes/code_of_ordinances?nodeId=COOR_TIT42ZOCO_CH67OULI_S67.030GESTFetched: 10/28/2026
