Residential Neighborhood.
Metropolitan Code of Nashville and Davidson County § 17.38.010.A
in effect17.38.010.A - Residential Neighborhood.
[image omitted; see the official code]
[image omitted; see the official code]
1. Intent. Intended for residential development, generally in the form of houses or townhouses, with private or shared open space. This district is appropriate for providing lower levels of density at strategic locations in urban and suburban areas—such as in transition zones near corridors, close to community amenities like parks and schools, or in areas with good access to arterial streets. Preference is given to locations with mass transit service.
2. Zones.
Zones | Context
Residential Neighborhood 1 (RN1) | Suburban
Residential Neighborhood 2 (RN2) | Urban
3. Allowed Building Types.
Single Family
Two Family
Townhouse
House Court
Townhouse Court
Plex House
Manor House (RN2 only)
Note 1: Detached Accessory Dwelling Units allowed with Single Family Building Types with conditions from Section 17.16.30.G, except for lot area, height, and setbacks, which are regulated by this chapter.
Note 2: Not-owner occupied Short Term Rentals are prohibited. Owner-occupied Short Term Rentals allowed with Single Family Building Type only per Section 6.28.30.
Note 3: Non-residential uses are permitted per Table 17.08.030 and are subject to the bulk standards for R6 in Table 17.12.020B.
4. Lot.
Lot Size | RN1 | RN2
Area | 6,000 sf min. | 5,000 sf min
Width | [image omitted; see the official code] | 60' min. | 40' min.
Depth | [image omitted; see the official code] | 90' min. | 90' min.
RN minimum lot area, lot width, and lot depth requirements shall be waived if in compliance with Section 17.40.670 and one of the following conditions are met: • The site has access to a side street or improved alley. • The width of the primary structure's main body is at least 18 feet wide, and the highest roofline of the primary structure does not exceed a ratio of 1.0 horizontal to 1.5 vertical.
5. Building Placement.
Setback | RN1 | RN2
Front (Build-To Zone) | [image omitted; see the official code] | 20' min.; 30' max. | 10' min.; 25' max
Side Street (Build-To Zone) | [image omitted; see the official code] | 15' min.; 25' max. | 5' min.; 15' max.
Side | [image omitted; see the official code] | 5' min. | 5' min.
Rear
Main Building | [image omitted; see the official code] | 15' min. | 15' min.
Accessory Structure(s) | [image omitted; see the official code] | 5' min. | 5' min.
Build-to shall align with the contextual setback (see Section 17.12.030.c(3)) when (1) the lot depth beyond the contextual setback is equal to or greater than the minimum lot depth required of the district or (2) the contextual setback is less than the build-to zone maximum. Otherwise, the build-to zone maximum is used.
Facade Zone | RN1 | RN2
Main building shall define required % of the linear length of the Front Build-To Zone | 50% min. | 50% min.
Main building shall define required % of the linear length of the Side Street Build-To Zone | 30% min. | 30% min.
Encroachments into Setbacks
Private Frontage Types may encroach into front and side street setbacks; and shall not be located in side or rear setbacks.
Architectural features may encroach up to 3 feet toward shared interior property lines, and up to 5 feet in all other building setbacks. Architectural features cannot cross property lines.
Fences, freestanding landscape walls, shrubs, and landscaping may encroach up to 3 feet into front or side street setbacks; and are allowed within side and rear setbacks.
Stormwater features may encroach into setbacks.
Encroachments are not allowed within utility easement area, ROW, alley, or across a property line.
Landscape Buffer
See Table 17.24.230 for landscape buffer yard requirements.
Landscape buffer yards within RN vary by building type.
No landscape buffer yard is required between properties zoned RN, regardless of building type.
No landscape buffer yard is required between properties zoned RN and RL.
Figure: 17.38.010.A(1). For A, B, C, D, E, F, and G see lettered sections in 17.38.010.A Table 4 and Table 5 for minimum and maximum requirements.
[image omitted; see the official code]
6. Building Form.
Height | RN1 | RN2
Main Building
Stories | 2.5 max. | 3 max.
See Section 17.38.020 for additional height standards. Building type standards may further limit height. Height shall be measured from the average grade plane post-development.
Highest Roof Line (H) | [image omitted; see the official code] | Maximums are set by building type.
Highest Eave (I) | [image omitted; see the official code]
Accessory Structure(s)
Stories | 2 max. | 2 max.
Highest Roof Line | 30' max. | 30' max.
Highest Eave | 24' max. | 24' max
Floor-to-Floor | RN1 | RN2
Ground Floor | [image omitted; see the official code] | 9' min. | 9' min.
Upper Floors | [image omitted; see the official code] | 8' min. | 8' min
Ground Floor Residential or Active Space | RN1 | RN2
Depth of active ground floor use along front and side street façade | [image omitted; see the official code] | 10' min. | 10' min.
Coverage | RN1 | RN2
Building Coverage | 0.4 max. | 0.5 max.
See Section 17.28 for Environmental Performance Standards.
Figure: 17.38.010.A(2). For H, I, J, K, and L, see lettered sections in 17.38.010.A Table 6 for minimum and maximum requirements.
[image omitted; see the official code]
7. Parking Location.
Setback | RN1 | RN2
Front | [image omitted; see the official code] | 10' behind facade | 10' behind facade
Side Street | [image omitted; see the official code] | 10' behind facade | 10' behind facade
Side | [image omitted; see the official code] | 3' min. | 3' min.
Rear | [image omitted; see the official code] | 3' min. | 3' min.
Dimensional Standards
15 feet maximum width for driveway curb cuts; unless required to be wider by the fire department.
Driveway curb cuts along an alley may be greater than 12 feet in width.
Parking shall meet the dimensional standards set forth in Section 17.20.060 of the Metropolitan Code.
Parking lot perimeter screening and interior planting requirements per Sections 17.24.140 and 17.24.160.
Figure: 17.38.010.A(3). For M, N, O, and P, see lettered sections in 17.38.010.A Table 7 for requirements.
[image omitted; see the official code]
(Ord. BL2025-1005 § 1(Exhs. A, F), 2025)
Source: Metropolitan Government of Nashville and Davidson County, Metropolitan Code and Charter (Municode Library, library.municode.com)URL: https://library.municode.com/tn/metro_government_of_nashville_and_davidson_county/codes/code_of_ordinances?nodeId=CD_TIT17ZO_CH17.38DESEMUMI_17.38.010.ARENEFetched: 10/28/2026
