23.22.020

A. Every preliminary plat application shall consist of one or more maps together with written data including the following: 1. The name of the proposed subdivision; 2. North arrow and scale; the location of existing property lines; streets, building, if any; watercourses and all general features; 3. The legal description of the land contained within the subdivision; 4. The names and addresses of all persons, firms and corporations holding interest in the lands, including easement rights and interest; 5. The proposed names, locations, widths, dimensions, and bearings of proposed streets, alleys, easements, parks, lots, building lines, if any, and all other information necessary to interpret the plat, including the location of existing utility and access easements that are to remain, all horizontal references (any reference to bearings, azimuths, or geographical or state plane coordinates) shall reference the horizontal datum for Seattle under Section 1.20.020 ; 6. The location of streets in adjoining plats and the approximate locations of adjoining utilities and proposed extensions into the plat; 7. The names of adjoining plats; 8. The name, address, telephone number, and seal of the registered land surveyor who made the survey or under whose supervision it was made; 9. The date of the survey; 10. All existing monuments and markers located by the survey; 11. The zoning classification applicable to the land within the subdivision; 12. The conditions of or the limitations on dedications, if any, including slope rights; 13. Contour intervals as required, based upon the vertical datum for Seattle under Section 1.20.020 ; 14. Property information including, but not limited to, address, legal description, and Assessor's Parcel number; 15. Evidence of ownership or authorization from the property owner to make the application; 16. A signed statement of financial responsibility by the applicant and owner acknowledging financial responsibility for all applicable permit fees; 17. Drainage plan; 18. Landscape plan; 19. Identification of any adjacent property within 300 feet of the proposed subdivision that is owned or controlled by the applicant; and 20. Specific location and description of all trees at least 6 inches in diameter measured 4½ feet above the ground, with species indicated. B. Any plat submitted that covers only a part of the subdivider's tract shall be accompanied by a sketch showing the proposed future street system in the remainder of the tract so that the street layout of the tract may be considered as a whole. C. The plat shall comply with the technical requirements of Subchapter V. D. For a preliminary plat of property entirely within the MPC-YT zone, an applicant may propose a single final plat for the entire property covered in the preliminary plat, or multiple final plats with each final plat covering a portion of the property covered in the preliminary plat. If an applicant proposes to proceed with more than one final plat, then the preliminary plat application shall designate which portion of the property, and facilities and improvements, will be included in each final plat. (Ord. 125781 , § 5, 2019; Ord. 123963, § 2, 2012; Ord. 121291, § 6, 2003; Ord. 119791, § 1, 1999; Ord. 118012, § 3, 1996; Ord. 110570, § 1(part), 1982.)