For AI agents: read the machine-readable documentation index at /llms.txt or the single-file full reference at /llms-full.txt.

§ 82.065 — Terracing and drainage

Salem Revised Code, City of Salem, Oregon (Supp. No. 26: codified through Ordinance No. 10-26, adopted August 10, 2026) · Salem Revised Code § 82.065

Corpus is an independent public-information project, not the official City of Salem website. Stable reference: corpuslaw.us/code/295cf3b2-55c9-4d10-b319-c1a8fd3c1037

Sec. 82.065. - Terracing and drainage.

(a) General. Unless otherwise recommended in a technical report, terracing and drainage facilities shall comply with the provisions of this section. (b) Terraces. (1) Terraces at least six feet in width shall be established at not more than 30-foot vertical intervals on all cut or fill slopes. Access shall be provided to allow for cleaning and maintenance. (2) Where more than two terraces are required, one terrace, located at approximately mid-height, shall be at least 12 feet in width. For cut or fill slopes greater than 60 feet and up to 120 feet in vertical height, one terrace at approximately mid-height shall be 12 feet in width. (3) Terrace widths and spacing for cut and fill slopes greater than 120 feet in height shall be designed by a certified professional. (c) Drainage facilities on terraces. (1) Swales or ditches shall be provided on terraces. The swales or ditches shall have a minimum gradient of 20 horizontal to one vertical and shall be paved with concrete not less than three inches in thickness, or with other materials suitable to the application. Swales and ditches shall have a minimum depth of 12 inches and a minimum width of five feet. (2) A single run of swale or ditch shall not collect runoff from a tributary exceeding 13,500 square feet without discharging into a down drain. (d) Interceptor drains. (1) Interceptor drains shall be installed along the top of cut slopes receiving drainage from a tributary width greater than 40 feet, measured horizontally. (2) Interceptor drains shall have a minimum depth of one foot and a minimum width of three feet. The slope shall not be less than 50 horizontal to one vertical. The drain shall be paved with concrete not less than three inches in thickness, or by other materials suitable to the application. (3) Discharges from the drains shall be accomplished in a manner to prevent erosion. (e) Drainage across property lines. Drainage across property lines shall not exceed that which existed prior to ground disturbing activity. Excess or concentrated drainage shall be contained on site or directed to a drainage facility. Erosion of the ground in the area of discharge shall be prevented. (f) Subsurface drainage. (1) Cut and fill slopes shall be provided with subsurface drainage as necessary for site stability. (2) Appropriate culverts shall be laid under all fills placed in natural watercourses and along the flow line of any tributary branches in such a manner that the hydraulic characteristics of any stream are not adversely altered. (3) Subsurface drainage shall be installed if active or potential springs or seeps are covered by the fill. (4) All culverts and subsurface drainage systems shall be installed after subgrade preparation. Design details of culverts and subsurface drainage shall be shown on the grading plan. (5) A subsurface drain system shall be provided for embedded foundation/retaining walls and floor slabs where groundwater or seepage has a potential to affect the performance of the structure. The grading plan shall indicate: (A) Subsurface drainage details with appropriate specifications; (B) Location of footing subsurface drain/discharge lines; and (C) Method of disposal. In lieu of above, walls/floors may be waterproofed and designed to resist hydrostatic pressure.

(Ord. No. 6-16, § 1(82.065), 5-23-2016)

Ask a question about Salem law

Corpus searches the Salem sections it holds and shows the ones that match, with their citations. Free, no sign-in.